3
Attach onto each, cloth and warp
beam, three Texsolv cords, using
the eight remaining screws.
Push the screw through the cord
loops; if you screw them through,
the thread may damage the cord.
Attach the cords in the direction
that is blocked by the ratchet.
Make loops in the cords and insert
the apron bars.
The apron bars are marked where
the cord loops should be
positioned.
Tighten the loops by pulling on the
apron bar.
After ensuring the cords at both
sides of the loops have even
tension, you can mark the middle
of the cords to help attachment of
the bars next time.
Assembling the shafts
Take eight of the shaft sides and
insert two shaft bars into each of
them.
