LOX ES15 User manual

ES15 WATER RESISTANT DOOR STRIKE
INSTALLATION MANUAL
INTRODUCTION:
WIRING AND POWER INPUT REQUIREMENTS:
SELECT EITHER THE 12V OR 24V SELECTOR PLUG TO SUIT THE VOLTAGE BEING USED, OR THE PLUGS MAY BE CUT OFF AND
WIRED AS BELOW.
The ES15 strike is designed to be surface mounted onto a door frame on a single swing door equipped with a surface mounted rim cylinder lock with
a sprung tongue lock. Rated strength 1200 kg
ES15 - Unmonitored weather resistant ( IP56 ) Electric Door Strike
• The ES15 is supplied with two voltage selection plugs for operation on either 12VDC or 24VDC.
• If space does not permit the use of the plug/s provided they may be cut o and wired as shown below.
• AC power may also be used by adding a bridge rectifier -- see below.
• Note that direct connection of AC power will damage the strike and is not covered by warranty.
• Power to the ES15 series is not polarized.
ALTERNATE WIRING USING AC 12 - 24 VOLTS WITH A
BRIDGE RECTIFIER
ALTERNATE WIRING WITHOUT VOLTAGE
SELECTION PLUGS
12VDC (0.20A)
Non Polarised
RED
BLUE
YELLOW
BLACK
24VDC (0.10A)
Non Polarised
RED
BLUE
YELLOW
BLACK
For AC operation a Jaycar ZR1304
Bridge Rectifier is recommended
AC from power source DC to strike
1mm clearance
KeeperDoor
Door latch
Door Frame
Front face of
strike keeper
When the door is closed, ensure that there
is no back pressure on the front of the strike keeper
Bridge Rectifier
PROBLEM POSSIBLE CAUSE SOLUTION
DOOR WILL NOT LOCK INCORRECT VOLTAGE SELECTION CHECK VOLTAGE PLUG BEING USED
WILL NOT WORK IN ONE ORIENTATION 24V RATHER THAN 12V SELECTED CHECK VOLTAGE PLUG OR WIRING
1OCTOBER 2020

DIMENSIONS AND MOUNTING OPTIONS
OCTOBER 2020
ES15 WATER RESISTANT DOOR STRIKE
INSTALLATION MANUAL
CHANGING LOCK FUNCTION FROM FAIL SAFE TO FAIL SECURE
WARNING:
DO NOT ATTEMPT TO SWIVEL THE KEEPER WHILE CHANGING THE FUNCTION, THIS WILL DAMAGE THE
BARBELL MECHANISM.
Step 1: Remove the security plug cover (2) with the provided security screw (1).
Step 2: Remove the spring screw (3) from the opening hole.
Step 3: Remove the Barbell (4) and replace in reverse position with long part in and short part out.
Step 4: Replace the spring screw (3).
Step 5: Refit the security plug cover (2).
Step 1: Remove the security plug cover (2) with the provided security screw (1).
Step 2: Remove the spring screw (3) from the opening hole.
Step 3: Remove the Barbell (4) and replace in reverse position with short part in and long part out.
Step 4: Replace the spring screw (3).
Step 5: Refit the security plug cover (2).
PROCEDURES TO CONVERT FAIL SECURE (FIGURE 4A) TO FAIL SAFE (FIGURE 4B):
PROCEDURES TO CONVERT FAIL SAFE (FIGURE 4B) TO FAIL SECURE (FIGURE 4A):
POWER TO OPEN
FIGURE 4A
9
Ø 5
12
31
32
3
3
36.9
countersunk
3535
94.5
93.5
POWER TO LOCK
FIGURE 4B
11
22
33
44
55
66
2