LOXONE Smart Socket Air User manual

Technical Specifications
Power supply 110 ... 230VAC, 50/60Hz
Standby power max. 500mW
Output protective contact socket outlet
(single-pole switched with internal
relay, bistable)
total load max. 10A (Plug Type J)
total load max. 13A (Plug Types E,
F, G)
Energy detection range 0 ... ∞ kW/h
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com
Need Help?
loxone.com/support
V060420
Part No: 100120 Plug Type E
Part No: 100115 Plug Type F
Part No: 100121 Plug Type G
Part No: 100119 Plug Type J
Smart
Socket
Air
Power loss at max. load 2.3W
Interfaces Loxone Air:
868MHz (SRD Band Europe),
4 channels available
915MHz (ISM Band Region 2),
10 channels available
max. Power 3.16mW
Ambient temperature -20 ... 35°C / -4 ... 95°F
Humidity max. 95% r.H. (non condensing)
Temperature detection range -40 … 125°C / -40 … 257°F;
+/- 0.5°C / 0.9°F
Power detection range 0 ... 4kW
Learn button can also be used as a push button

About the product
The Smart Socket Air gives you simple and convenient
wireless control of devices and appliances.
With an in-built temperature sensor and power monitor, you
can easily keep track of how much energy your appliances
are using, and switch them off remotely via the Loxone app.
Features
• Freely programmable relay output
• Power and energy measurement
• Temperature sensor
Installation
The installation of the device has to be carried out by a
qualified person. The device has to be fitted in accordance
with building regulations for electrical and fire safety. If the
device is not installed according to manufacturers guidelines
the protection of the device may be affected.
Prior to the installation it’s important to read our online
documentation.
When the Smart Socket Air is first plugged in, learning mode
will be activated for 10 minutes or until the device has been
successfully paired with a Miniserver using Loxone Config.
For additional information, declaration of confirmity,
visit www.loxone.com/help/smart-socket-air
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including
interference that may cause undesired operation
Plug Type E
Learn Button
Plug Type F
Learn Button
Plug Type G
Learn Button
Plug Type J
Learn Button
This folder is a part of the product!
Safety Rating IP30
Maintenance & Cleaning This device is free of
maintenance and may only be
cleaned with a dry cloth.
Dimensions 106x53.8x29.5mm / 4.17x2.12x1.16”
(LxWxH) (without plug)
Technical Specifications