LOXONE NFC Code Touch Air User manual

Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com
Need Help?
loxone.com/support
V140420
Part No: 100299 (White)
Part No: 100305 (Anthracite)
NFC
Code
Touch
Air
Technical Specifications
Power supply 9 ... 28VDC or CR2450 battery
Power consumption typ. 0.08W, max. 0.8W (while
reading NFC)
Ambient temperature external power supply:
-20 … 70°C / -4 … 158°F
battery powered:
-20 ... 60°C / -4 ... 140°F
Humidity max. 95% r.H. (non condensing)
Maintenance & Cleaning This device is free of main-
tenance and may only be
cleaned with a dry cloth.
Interfaces Loxone Air:
868MHz (SRD Band Europe),
4 channels available
915MHz (ISM Band Region 2),
10 channels available
max. Power 3.16mW
Access possibilities NFC, Key code
Click feedback Yes
Touch points capacitive touch detection
Safety rating IP44
Power loss max. 0.8W
Connection
Wire cross-section 0.25 ... 0.8mm² / AWG23 ... 18
Stipping length 5mm / 0.2"
Temperature resistance -40 … 105°C / -40 … 221°F
Battery lifetime up to 1 year

About the product
Get access with encrypted or unencrypted NFC tags, via your
NFC enabled smartphone or through your own unique key
code.
Features
• Authentication via encrypted and unencrypted NFC Tags or
NFC enabled smartphones or key code
• Supports permanent, disposable or time-limited key codes
• Universal button
• Alarm-authentication
Installation
Install the mounting frame of the NFC Code Touch on the
desired installation place. Power up the device and pair it with
your Miniserver in Loxone Config. Alternatively you could power
up the device with the provided battery, but note that due to
higher need of power the authentication with NFC and the
background light will not work. To finish the installation attach
the NFC Code Touch as shown on the mounting frame.
For additional information, declaration of confirmity,
visit www.loxone.com/help/nfc_code_touch
Important Information
•
•
Due to the higher power demand, the NFC-Reader and
background lighting will only work when the device is
externally powered.
For security reasons, we strongly suggest you only use
encrypted NFC tags for access control from Loxone.
• If the NFC Code Touch is being powered by battery, please
note the keypad must be woken up with the check mark
prior to entering the key code.
+ 24V
GND
Universal
button Attach hereNFC Sensor
Power supply
or battery
powered
Learn
button