About the product
Loxone Valve Actuator Air offers smart heating and cooling
control on a room-by-room basis.
Features
•Valve control
•Interchangeable valve adapters (VA80 included)
Installation & electrical connection
Mounting of the equipment must be performed by a qualified
technician. During mounting and in case of error a separator
(at least 4A) must be present to turn off the supply.
The separator must be easily accessible and recognizable.
For additional information, declaration of confirmity,
visit www.loxone.com/help/valve-actuator-air
Learn Button &
Status LED
GND
+24VDC
Connection
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
2.
This device may not cause harmful interference
This device must accept any interference received,
including interference that may cause undesired operation
This folder is a part of the product!
IDC-Technology The wires of a cable are pressed
into a single insulation cutting
terminal. This connection
technique works without
soldering, screwing and stripping.
Wire cross-section 0.26 ... 0.34mm² / AWG23 ... 22
Temperature resistance -40 … 105°C / -40 … 221°F
Power supply
or battery
powered
