Lumascape LS353 User manual

Warranty voided if not installed as per installation instructions
INSTALLATION INSTRUCTIONS
Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T 07 3286 2299
F 07 3286 6599
E [email protected]
W www.lumascape.com.au
FOR OUTDOOR USELS353: Shallow Inground with MicroAntileach™ cable
A.C.N. 0105 72 773
1x
Connect luminaire to suitable power
supply.
Discard plastic lid and black o-ring.
Discard alluminium lid.
RETAIN GASKET.
Flushed floor/ground level
Check gasket beading
faces down into cavity
Fit stainless steel lid. Tighten screws.
1.
4. 5.
2. 3.
6.
IN0033 - 27 May 2013
1x 1x
10x
1x
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
Finished floor level
Power supply must be isolated prior to
connection or disconnection of cables.
Failure to do so will result in damage to
the luminaire components.
DISCONTINUED PRODUCT

Copyright ©2013 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
www.lumascape.com.au
15 Min.
15°
IN0033 - 27 May 2013
7.
10.
8. 9.
WARNING - To reduce the risk of FIRE or INJURY:
1. Luminaires and transformers to be installed by quality installers only.
2. Luminaires to be used for intended purpose only. e.g. Wall Mount ttings must be wall mounted.
3. Luminaires can become very hot. Use discretion in placement.
4. Do not touch hot lens, guard, or enclosure.
5. CAUTION - HOT SURFACE. Keep away from curtains and other combustible material.
6. Turn Off/Unplug and allow to cool before replacing lamp.
7. Keep lamp away from materials that may burn.
8. Never touch lamp with bare ngers. Oil from skin may damage lamp. Hold lamp with soft
cloth when installing or replacing.
9. Do not operate the luminaires with a missing or damaged parts.
10. Replace any cracked protective shield.
11. Use only lamp type, voltage and wattage as specifed by Lumascape on the product label.
12. Use only genuine Lumascape parts to replace damaged or missing components.
13. Refer to instructions for installation and operating requirements.
14. Ensure installation complies with local regulations
Voltage insulation test (megger) will permanently damage product and will void warranty.
SAVE THESE INSTRUCTIONS.
SAFETY INSTRUCTIONS
Questions?
Call 07 3286 2299
Email [email protected]
www.lumascape.com.au
DISCONTINUED PRODUCT