LumenRadio W-DALI User manual

Wireless Without Worries
W-DALI DIN RAIL OPERATION
W-DALI DIN RAIL MODES
Green LED indicates LumenRadio wireless DALI mode
for DALI transparent operation. This is the default mode.
White LED indicates DALI forward frame mode for basic
lighting control setups. In this mode only DALI forward
frames will be sent.
Only the W-DALI DIN rail requires modes settings, no
additional settings are needed for the W-DALI node.
Instructions for use
<1s
Power ok, wireless DALI mode
Power ok, DALI forward mode
Linking
Linking
Link subnet 1
Link subnet 2
Connect with phone
App mode - connected
Available for connecting with phone
DALI data detected
Stop linking and go to
secure mode
Non connectable with phone
<1s
>5s
<5s
>5s >5s
<5s
Power OK, wireless DALI mode
Power OK, forward frame mode
>5s

Wireless Without Worries
To manually link W-DALI nodes to the system, follow these steps:
1. On both the W-DALI DIN rail and W-DALI node, set
the subnet switch to either subnet 1 or 2. This will al-
low for simultaneous linking of two different W-DALI
networks.
2. Press and release the button on the front panel of
the W-DALI DIN rail within 1 second.
3. The W-DALI nodes that receive the linking signal
from the W-DALI DIN rail will start a pulsing fade
with an intensity of 50% - 80% - 50%.
4. Wait for all W-DALI nodes to join the system.
5. Once all nodes have joined, press the button again
on the W-DALI DIN rail to stop the linking process
and enter operational mode. Alternatively, If the but-
ton is not pressed, the W-DALI DIN rail will automati-
cally enter operational mode after 1 hour.
Linking mode
<1s
<1s
Secure mode
100%
50% - 80% - 50%

Wireless Without Worries
To unlink W-DALI nodes, please follow these steps:
1. Disconnect the power supply to the W-DALI node
that needs to be unlinked.
2. Change the position of the switch to the opposite
setting.
3. Restore power to the W-DALI node.
4. The W-DALI node is now reset and ready to be
linked again.
0
0
1
AC OFF
AC OFF
AC ON

Wireless Without Worries
An alternative method for manually linking W-DALI nodes in systems with more than 2 subnets:
1. Disconnect the power supply to the W-DALI node
that should not be linked.
2. Press and release the button on the front panel
within 1 second of the rst W-DALI DIN rail.
3. Wait for all W-DALI nodes to join the system.
4. Once all nodes have joined, press the button again
on the W-DALI DIN rail to stop the linking process
and enter operational mode.
5. Restore power to the next batch of W-DALI nodes
that should be linked to the next W-DALI DIN rail.
There is no need to disconnect power to the already
linked W-DALI nodes.
6. Repeat steps 2 to 5 until all W-DALI nodes have
been linked.
<1s
1
AC ON
<1s
<1s
0
AC OFF
1
AC ON
1
AC ON
0
AC OFF