Magtek cDynamo User manual

Connection
Connect the Top and Bottom Enclosures cDynamo SCRA
enclosure is made up of two pieces that easily snap together
around the iPad. Place the iPad device inside the top enclosure.
Be sure the iPad slides to the top and snaps in place.
Slide the bottom enclosure into place by lining up the Lightning
connector on cDynamo and the Lightning port of your iPad device.
Sections 1 and 3 shown in the diagram should snap in place to the inside of
the enclosure, and section 2 should snap to the outside of the enclosure.
When removing the iPad from the top enclosure, pull both sides out
so the case is pushed past the buttons on your iPad device.
USB cable micro-USB cable. Part Number (PN) 1000002547
Power
cDynamo is powered through the iOS device. It only uses power during a
transaction. To charge your iOS device while cDynamo is attached, connect
the optional micro-USB cable (micro-B) to the back of cDynamo, and then
connect the opposite end (USB-A) to the appropriate Apple charging adapter.
Connection - USB Port
Plug the micro-USB connection end of the cable into cDynamo’s micro-
USB port, then attach the USB connection to your Apple charging adapter.
Pass-through micro-USB port allows the iPad device to charge without
disconnecting cDynamo.
Connection - Lightning
Lightning connector supports charge ONLY; iTunes
synchronization is not available.
Mounting
VESA Mount = MIS-D 4”x 4” (100mm x 100mm), Qty 4 - M4 screw threads.
cDynamo makes mobile payments and card reading easier than ever. The
form tted enclosure is perfect for high trafc merchants, in-ight sales, line-
busting, and pay-at-the-table service. cDynamo delivers an integrated secure
card reader authenticator for magstripe cards with a long smooth swipe
path for excellent rst swipe read rates
Major Components
cDynamo
Secure Card Reader Authenticator
made for iPad
Quick Installation Guide
Setup and Installation
MagTek®Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 562-546-6800 | f 562-546-6301 | www.magtek.com
MagTek®, MagnePrint®, and MagneSafe® are registered trademarks of MagTek, Inc.
MAGTEK: Registered to ISO 9001:2015 © Copyright 2022 MagTek, Inc. PN D998200074 rev 50 10/22
173.50
286.56
18.37
D
C
B
A
B
C
D
1
2
3
4
5
6
7
8
8
7
6
5
4
3
2
1
A
SHEET 1 OF 3
DESIGNED BY
S.SHARMA
0.254
DO NOT SCALE DRAWING
CCA
NA
DRAWN BY
TOLERANCE:
2.540
TITLE:
6/17/2015
ABS
B
SIZE
PROPRIETARY AND CONFIDENTIAL
20
S.SHARMA
FINISH:
.X
ANGLES
CDYNAMO IPAD AIR
DWG REV :
CHECKED BY:
DATE
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF MAGTEK. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF MAGTEK IS PROHIBITED.
.XXX
SCALE: 1:4
.XX
MUST BE ROHS COMPLIANT, SEE
EUROPEAN DIRECTIVE 2002/95/EC
DIMENSIONAL UNITS:
2°
DWG NO.
MATERIAL:
0.127
MM
PART NO.
D100003407 21087005
USB A PLUGRIGHT ANGLE MICRO USB B PLUG
micro-USB port
Front Back
MagneSafe® secure card reader authenticator (SCRA)
Lightning™ connector
Top enclosure
Bottom enclosure
1
23

Product Compatibility
Made for
iPad Air
iPad Air 2
iPad (iPad “Flat-out Fun”)
iPad mini 3
iPad mini 2
cDynamo comes in two different enclosure sizes:
PN 21087005 with VESA mount
Made for
iPad Air
iPad Air 2
iPad (iPad “Flat-out Fun”)
PN 21087006 in mobile hand-held form
Made for
iPad mini 3
iPad mini 2
Card Read
A card may be swiped through the reader slot. The magnetic stripe must
face toward the back of the device and may be swiped in either direction.
Technical Support
When contacting the support team please have your reader charged and
have the part number and serial number(s) available.
Call 562.415.6800 or email: [email protected]
Use and Compliance
Please note that the use of this accessory with an Apple product may affect wireless performance. Apple®, Apple Pay®, OS X®, iPhone®, iPad®, iPad Air®, iPad Pro®, Lightning®, and Mac® are trademarks of Apple Inc., registered in the U.S. and other countries.
EMV® is a registered trademark in the U.S. and other countries and an unregistered trademark elsewhere. The EMV trademark is owned by EMVCo, LLC. The Contactless Indicator mark, consisting of four graduating arcs, is a trademark owned by and used with
permission of EMVCo, LLC. MagTek®, MagnePrint®, and MagneSafe® are registered trademarks of MagTek, Inc.
MAGTEK: Registered to ISO 9001:2015 © Copyright 2022 MagTek, Inc. PN D998200074 rev 50 10/22
MagTek®Inc., 1710 Apollo Court, Seal Beach CA 90740 | www.magtek.com
cDynamo - Secure Card Reader Authenticator
FCC
FCC WARNING STATEMENT: This equipment has been tested and was found to comply with the
limits for a Class B digital device pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a
residential environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference with radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
FCC COMPLIANCE STATEMENT: This device complies with Part 15 of the FCC Rules. Operation
of this device is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Canadian
CANADIAN DOC STATEMENT: This digital apparatus does not exceed the Class B limits for radio
noise from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le brouillage
radioélectrique édicté par le ministère des Communications du Canada.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numériqué de la classe B est conformé à la norme NMB-003 du Canada.
CE
CE STANDARDS: Testing for compliance with CE requirements was performed by an independent
laboratory.
The unit under test was found compliant with standards established for Class B devices.
UL/CSA
UL/CSA: This product is recognized per Underwriter Laboratories and Canadian Underwriter
Laboratories 1950.
RoHS
RoHS STATEMENT: When ordered as RoHS compliant, this product meets the Electrical and
Electronic Equipment (EEE) Reduction of Hazardous Substances (RoHS) European Directive
2002/95/EC. The marking is clearly recognizable, either as written words like “Pb-free”, “lead-free”,
or as another clear symbol ( ).
Apple Legal Notice
“Made for iPad” means that an electronic accessory has been designed to connect specically to
iPad and has been certied by the developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with safety and regulatory standards.
Please note that the use of this accessory with iPad may affect wireless performance.
Credit lines and trademark symbols
AirPlay, iPad, iPhone, iPod, iPod classic, iPod nano, iPod touch, and Retina are trademarks of Apple
Inc., registered in the U.S. and other countries. iPad Air, iPad mini, and Lightning are trademarks of
Apple Inc.
Pb