MANCHESTER WOOD Cherry Contemporary Media Stand User manual

CONTEMPORARY MEDIA
STAND
Thank you for purchasing our Cherry Media Stand.
Assembly of this product requires a Phillips screwdriver
and a 7/16” wrench.
2278

STEP 1
Read through these instructions
thoroughly. We have found this to be of
great value when first assembling this
product.
STEP 2
Remove all parts and hardware from
packing material. Place wooden parts on
non-abrasive surface (like carpet or
carton) to prevent damage to finish.
Identify all parts using diagram at right.
Parts
(A) Top
(B) Middle Shelf
(C) Legs w/Hanger Bolt (4x)
(D) Bottom Shelf
STEP 3
Identify and count hardware using
diagram at right.
Assembly of this product requires
a Phillips screwdriver and a 7/16”
wrench.
STEP 4
Attach two Legs (C) on same side to
Middle Shelf (B) by threading attached
hanger bolt on Legs (C) through
countersunk hole in edge of Shelf (B)
as shown on right. Use washer and lock
nut to secure with 7/16” wrench.
Repeat this step with Bottom Shelf (D)
show in Step 5.
STEP 5
Attach two Legs (C) on other side to
Bottom Shelf (D) and Middle Shelf (B)
by threading attached hanger bolt on
Legs (C) through countersunk hole in
edge of Shelves (B, D). Use washer and
lock nut to secure with 7/16” wrench.
Secure all nuts on all four legs.

STEP 6
Turn assembled Legs (C) and Middle Shelf
(B) upright so that holes in the ends of each
Leg (C) are facing up.
STEP 7
Attach Metal Bracket to the top of Legs (C)
by inserting one 2” #8 screw through center
hole of Metal Bracket, and into predrilled
hole in the top of Leg (C). Repeat for each
Leg (C) as shown on right.
Note: Ensure each Metal Bracket sits at a
90-degree angle on the Leg (C) before fully
tightening the screw. Refer to the photo to
the right for the proper placement of the
Metal Bracket.
STEP 8
Place Top (A) face down on non-abrasive
surface (carpet or carton) so that the inlays
and holes are facing up as shown in photo to
the right. Assemble unit by placing attached
Metal Bracket on Legs (C) face down.
Secure with ½” #8 screws in allotted
predrilled holes.
CARE
Dust as needed with soft cloth. Clean with
damp cloth and mild solution of dish soap.
Polish with soft cloth and polish that
contains no pigment or silicone.
www.manchesterwood.com
Product Support 1-800-660-6930