Masimo ALERT User manual

Quick Start Guide
Bedside Station
- Collects data from Masimo Sensor.
- Sends data to smartphone app.
- Reusable chip snaps into the sensor and
communicates with the Bedside Station.
Masimo Chip™
- Additional tapes for replacement
as needed.
Replacement Tapes
- Displays Oxygen, Pulse Rate and other data.
- Cloud sends alerts to Bedside Station and
Mobile device.
- Compatible with most mobile devices.
(mobile device not included)
Masimo SafetyNet Alert App
Set Up App
2. Connect bedside station to power 4. Follow step-by-step instructions on app to
set up system
1. Download app 3. Look for power
indicator light
© 2021 Masimo. All rights reserved. 302386/11129D-0621
Masimo Sensor™
- Disposable sensor measures oxygen level
and pulse rate and lasts 7 consecutive nights.*
*Based on 96 hours of sensor battery life.
Remove chip between uses.
SYSTEM COMPONENTS
MASIMO SAFETYNET
ALERT
™
1

Visit http://www.mymasimo.co.uk
/safetynet-alert to see full list of
supported devices, purchase additional
sensors and view other resources,
including videos and instructions.
Changing the Replacement Tape
1. Remove used tape
from sensor
2. Attach new tape in same
direction as used tape
3. Attach sensor to finger 4. Peel the remaining
tape off backing
3. Place sensor on wrist as shown and
carefully thread the tip of the strap
through the open
red loop
4. Wrap the loose end of the strap
around your wrist and press
1. Remove sensor from pouch 2. Peel off yellow label
to activate battery
1. Remove part of the plastic film
and place star ( ) on top of
fingernail of ring finger
2. Wrap tape around finger so
black square ( ) is on finger
pad directly across from star ( )
4. Remove plastic film
and continue to wrap
tape around finger
3. Squeeze top and bottom
of finger to secure tape
5. Adjust cable to
comfortable length
Listen for click
to confirm
chip placement
Look for light to
confirm chip
connection to sensor
2. Insert the chip into open
compartment on the sensor
3. Press down on the
chip to secure
1. Hold the chip near the
bedside station and
listen for double beep
1. Once the chip is inserted, the Bedside Station Bluetooth
Status LED will turn off and the Status LED will turn green.
The chip light indicator will turn solid blue.
Set Up Sensor
Apply Sensor
Pair and Insert Chip
Confirm Successful Pairing
2
3
4
5