Masimo SafetuNet Alert User manual

SAFETYNET ALERT
SAFETYNET ALERT
SET UP APP
SYSTEM COMPONENTS
© 2021 Masimo. All rights reserved. 302386/11129E-1021
Oxygen Monitoring & Alert SystemOxygen Monitoring & Alert System
Masimo SafetyNet Alert™
Masimo SafetyNet Alert App
- Displays oxygen, pulse rate and other
data.
- Cloud sends alerts to Home Medical
Hub and mobile device.
- Compatible with most mobile devices.
(Mobile device not included.)
Home Medical Hub
- Collects data from Masimo Sensor.
- Sends data to smartphone app.
Replacement Tapes
- Additional tapes for replacement as
needed.
Masimo Chip
- Reusable chip snaps into the sensor and
communicates with the Home Medical Hub.
Masimo Sensor
- Disposable sensor measures oxygen level and
pulse rate and lasts 7 consecutive nights.*
*Based on 96 hours of sensor battery life.
Remove chip between uses.
1. Download app. 2. Connect Home Medical Hub to power. 3. Look for power
indicator light.
4. Follow step-by-step instructions
on app to set up system.
Quick Start Guide
SAFETYNET ALERT
1

CHANGING THE REPLACEMENT TAPE
Listen for click
to confirm
chip placement
Look for light to
confirm chip
connection to sensor
1. Remove sensor from pouch. 2. Peel off yellow label to
activate battery.
3. Place sensor on wrist as shown and carefully
thread the tip of the strap through the open
red loop.
4. Wrap the loose end of the strap
around your wrist and press to
secure.
1. Once the chip is inserted, the Home Medical Hub Bluetooth
Status LED will turn off and the Status LED will turn green.
The chip light indicator will turn solid blue.
3. Attach sensor to finger2. Attach new tape in same
direction as used tape
1. Remove used tape
from sensor
4. Peel the remaining tape
off backing
2. Insert the chip into open
compartment on the sensor.
1. Hold the chip near the
Home Medical Hub and
listen for double beep.
3. Press down on the chip
to secure.
3. Squeeze top and bottom
of finger to secure tape.
4. Remove plastic film
and continue to wrap
tape around finger.
5. Adjust cable to
comfortable length.
2. Wrap tape around finger so black
square ( ) is on finger pad
directly across from star ( ).
1. Remove part of the plastic film
and place star ( ) on top of
fingernail of ring finger.
Visit http://www.mymasimo.co.uk/safetynet-alert
to see full list of supported devices, purchase
additional sensors and view other resources,
including videos and instructions.
SET UP SENSOR
APPLY SENSOR
PAIR AND INSERT CHIP
CONFIRM SUCCESSFUL PAIRING
2
3
4
5