2
SAFETY INFORMATION
• Follow workshop health & safety rules,
regulations and conditions when using
worklight.
• When not in use, worklight should be stored
in a dry location to inhibit rust.
• During their period of use, accessories
must be checked for wear, cracks and other
damage, replace any damaged or worn parts.
• Use genuine parts only. Unauthorized parts
may be dangerous and will void the warranty.
• Keep the worklight clean and in good working
order for best and safest performance.
• DO NOT use the lamp in the immediate
vicinity of inflammable materials or gases.
• DO NOT point the light directly in your own or
any other person’s or animal’s eyes.
• DO NOT drop, throw or abuse the worklight.
• Eyes protection: Wear a protective mask or
protective eyewear.
• Check that the product has not suered any
damage during transport or storage. Clean
and remove any dust or residual packing
material.
• Read the instructions carefully before using
worklight and keep them for further reference.
WARNING!
• DO NOT immerse worklight in water.
• DO NOT place worklight near a fire or any
other source of intense heat.
• DO NOT attempt to open, disassemble,
modify or service the worklight.
• DO NOT expose worklight to temperatures
above 50°C (122° F).
• DO NOT use worklight if you suspect that the
casing is damaged
• DO NOT exceed the total load above 3000W.
PACKAGING CONTENT
DESCRIPTION QTY.
Worklight 1
O.I.P.M. 1
OPERATING INSTRUCTION
1. To use the worklight, plug in the worklight to
an AC power source.
2. Switch ON / OFF the worklight using the
switch provided on the front of the worklight.
3. To use the worklight in series, make sure that
all the lights are disconnected from the AC
power source to avoid any accidents.
4. Open the protective cap of the socket of
the first worklight and insert the plug of the
second worklight in it. Similarly, more lights
can be connected in series.
5. Connect the plug of the first worklight in an
AC power source and switch ON the power
source.
6. Ensure that the combined load of all the
devices connected in series is within the
3000W limit
MAINTENANCE
• Clean any dirt from the housing or the lens
immediately, since it could cause overheating.
• If required, clean with a dry or slightly moist
clean cloth. Do not use cleaners that contain
abrasives or solvents.
• When not in use, worklight should be stored
in a dry location.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
If the worklight doesn't work Loose connection or power source not
working
Check for loose connections and check power
source
If the worklight still doesn't work Contact nearest authorized service dealer
DISPOSAL
The components or the used products must be given to companies that specialize in the disposal and
recycling of industrial waste.
TROUBLE SHOOTING
