2
SAFETY INFORMATION
• Follow workshop health & safety rules,
regulations and conditions when using the
worklight.
• When not in use, worklight should be stored in
a dry location to inhibit rust.
• During their period of use, accessories must be
checked for wear, cracks and other damage,
replace any damaged or worn parts.
• Use genuine parts only. Unauthorized parts
may be dangerous and will void the warranty.
• Keep the worklight clean and in good working
order for best and safest performance.
• DO NOT use the lamp in the immediate vicinity
of inflammable materials or gases.
• DO NOT point the light directly in your own or
any other person’s or animal’s eyes.
• DO NOT drop, throw or abuse the worklight.
• Eyes protection: Wear a protective mask or
protective eyewear.
• Check that the product has not suered any
damage during transport or storage. Clean and
remove any dust or residual packing material.
• Read the instructions carefully before using
worklight and keep them for further reference.
WARNING!
• DO NOT immerse the worklight in water.
• DO NOT place the worklight near a fire or any
other source of intense heat.
• DO NOT attempt to open, disassemble, modify
or service the worklight.
• DO NOT expose the worklight to temperatures
above 40°C (104° F).
• DO NOT use the worklight if you suspect that
the batteries or the casing is damaged
PACKAGE CONTENT
DESCRIPTION QT Y.
10W COB Rechargeable worklight with
bluetooth speaker
1
Type C USB cable 1
O.I.P.M. 1
OPERATING INSTRUCTIONS
LED Display at back shows charge levels in
percentage of battery remaining in the worklight
along with real time lumen output.
1. Fully charge the battery before the first use.
To charge, connect the worklight with Type C
USB charger cable provided with it.
2. While charging, the battery icon will blink
continuously on the LED screen.
3. When the battery is fully charged, the battery
icon will show 100%. Full charging takes about
2 hours.
4. Press the power button located at the back of
the light
• Once for top torch “ON”
• Twice for worklight “ON”
• Three times for continuous red light “ON”
• Four times for red SOS flashing “ON”
• Five times for switching “OFF” the light
5. Intensity of all four modes of light can be
controlled pressing the increase (+) or
decrease (–) buttons at the back of the
worklight.
6. For bluetooth connection of worklight to
phone, press and hold the power button for
switching on the Bluetooth of the worklight
and connect to “BT500” from your phone.
7. Built-in Mic is provided in the worklight for
taking calls while working.
8. The worklight can also be used as power bank
for charging mobile devices.
MAINTENANCE
• Clean any dirt from the housing or the lens
immediately, since it could cause overheating.
• If required, clean with a dry and clean cloth.
Do not use cleaners that contain abrasives or
solvents.
• When not in use, worklight should be stored in
a dry location.
TROUBLESHOOTING
PROBLEM POSSIBLE
CAUSE
CORRECTIVE ACTION
Worklight does not
work
Low battery Recharge the battery
The Bluetooth
speaker does not
work
Bluetooth
out of range
Worklight and the
phone should be within
10 meter (33ft) range
If the COB
Rechargeable
worklight with
bluetooth speaker
still doesn't work
Contact nearest
authorized service
dealer
DISPOSAL
The components or the used products must be
given to companies that specialize in the disposal
and recycling of industrial waste.
LED 397 neutral.indd 2LED 397 neutral.indd 2 01-10-20 11:09:03 AM01-10-20 11:09:03 AM
