Max Keystone Series Manual
31/08/16
Rotate the base
180° on both
Latch and the
Button.
IMPORTANT:
Be careful not
to disturb inner
components.
RIGHT
GATE
LEFT
GATE
Undo
screws
Mark Latch position on
the side of fence post.
Set template point on
pencil line. Mark all holes
on both sides of post.
Drill two Ø16mm spindle holes.
Drill all other holes to Ø3mm.
Make sure they’re square & level.
70
16
16
START 180°
View from inside the Property
Make these changes for
Left-Hand Gates.
FENCE
Viewed from
inside the Property
Left or
Right?
The Latch comes ready
for Right-Handed gates. A
few simple steps and the
Latch is ready for
Left-Handed gates.
GRAVITY
Latch
Two-Way
Access
- Suits 50 - 125mm Posts
- Lock-unlock either side
- Lock-down mode –
won’t open
without key
DPG200
won’t open
without key
Use one screw to hold Button body on
fence post.
Trim plastic tubes to match post depth
and insert.
Check both sides are unlocked. Hold the
Latch in place and test the Button works
the Latch.
All good? Completely mount Latch and
Button.
Not working? See Troubleshooting below.
Sit Striker in Latch and mark the Striker’s
centre on gate. Drill pilot holes and mount.
Test the locking and unlocking of the Latch
and Button.
Protrudes
7mm
Protrudes
13mm
Maintenance
• Inspect Latch annually or more frequently if the gate is used often.
• Only lubricate with powdered graphite lubricant. No petroleum-based lubricants, oils etc.
• Keep Latch free of contaminants
TROUBLESHO OT ING
If it doesn’t lock, rotate Lock Spindle 180°.
1. Remove keys.
2. Remove Latch off post.
3. Hold the Key, rotate Lock Spindle 180°.
4. Remount Latch, careful not to turn Lock
or Spindle.
Continued
To protect the
Latch from slam
damage add a
Gate Stop.
Lock
Spindle
Button
Spindle
Trim Spindles
Button
POST (mm) TRIM MARK
50 2
75 4
90 5
100 6
125 no trim
Trim both Spindles using the trim
marks.
2456
2456
33
37
50 to 125
25
57 25
140
52
140
32
5
8
75
19
8
51
5
70 89
43
Note:
Maintenance:
WARRANTY
MANUFACTURER’S
NATIONWIDE INDUSTRIES Tampa, Florida 33619 USA
Keystone® Series Latches
What Does This Warranty
Cover?
as well as any loss of
warranty, manufacturer will
return the product, please
paid, together with proof of
What Does This Warranty Not Cover?
altered, misused, eglected, damaged, improperly installed
unauthorized person, or used in any manner which is not in
whether in contract, in tort, under warranty, in negligence or
for the safety of those in or around the pool and, to the extent
cannot and will not accept responsibility for unauthorized
properly, it should be returned promptly to the supplier for
Million Cycle Warranty and Liability Limitation
This manual suits for next models
1
Other Max Gate Opener manuals
