Maxeon SunPower Reserve User manual

SunPower Reserve Quick Installation Guide
Home energy storage system (RESERVE-BAT-1-DC-10.1-INT)
548267 Revision B - Jun 2023
1.0 Transport
2.2 Dimensions
2.0 Product Overview
Risk of injury when lifting the battery as the battery weighs 90 kg. There is risk of injury if the battery is lifted
incorrectly while being transported.
Transport the battery always as described below.
Handle with care, choose the corresponding handling method according to the weight, and pay attention to safety.
For additional batteries, keep a minimum spacing of 300mm. Do not stack batteries.
During transportation, please follow these guidelines:
1. The original packaging should be used for transportation.
2. Handle with care, choose the corresponding handling method according to the weight, and pay attention to safety.
3. Duringtransportation,pleasekeepthepackagingawayfromdangeroussourcesandtakewaterproofingmeasures.
4. Secure the packaging during transportation.
(1)
(2) (4) (5)
(8)
(6)
(7)
(6)
(*)
(3)
Position Description
1 Battery Start Button
2 Battery Circuit Breaker
3 Battery LED Display
4 Battery+ Power Connector
5 Battery- Power Connector
6 Grounding terminal
7 BMS COM (1)
8 BMS COM (2) (with terminal resistor)
2.1 LED Display
The three LED indicators on the front cover provide information about the State of Change (SOC) operational status of the battery.
State of Charge (SoC) Description
SOC≤10%
10%<SOC≤30%
30%<SOC≤50%
50%<SOC≤60%
60%<SOC≤90%
90%<SOC≤100%
Symbol Description
WhiteLEDsash
White LED on
LEDsareo
610mm
829mm
250mm
212mm
≥300mm ≥300mm ≥300mm
≥300mm≥300mm≥300mm≥300mm ≥300mm
12
6
2.3 Scope of Delivery
2.4 Mounting Location
BATTERY (RESERVE-BAT-1-DC-10.1-INT)
Battery Pack (x1) Left Side Plate (x1) Right Side Plate (x1) Wall bracket (x1) M5x12 (x3)
Limit Bracket (x2) Plastic set screws (M5-L8)
(x12)
Plastic Blockage (x4) Wall Anchor and Expansion
Screws (x4)
Y type Terminal Blocks (x2)
Battery Quick Installation
Guide (x1)
Grounding Cable (x1) Expansion Battery Positive
Power Cable (x1)
Expansion Battery Negative
Power Cable (x1)
90°
IP65 90kg
0°
-10°C
50°C
2.5 Installation
633mm
≥15mm ≥70mm
Ø10mm
1. 2.
0°
≥70mm
SW10
M6
Remove
Ø10mm
1
23
4
5
6 6 6
CAUTION
CAUTION
NEED MORE HELP?
 Ifyouwouldliketocontactusdirectly,pleasevisitourocialwebsite:
https://sunpower.maxeon.com for more information.

• DONOTshortcircuitthebatteryterminals.First,completethe-terminalconnectionsbetweenbatteryand
inverter and then complete the + terminal connections.
• Touchingashortedbatteryconnectionmayresultinlethalinjuriesduetoelectricshockandmassiveenergy
release.
• Switchothebatterybreakerlocatedontherightsideofthebatterywhenmakingconnections.
• Pleaseconnectbothendsofonebatterypowercablecompletelybeforeconnectingthenextpowercableto
avoid short-circuiting of the positive and negative battery power cables.
2.6.2. Connecting to the Inverter Parts
2.6.3. Connecting more Batteries
BAT+
BAT-
Please remove the insulated sleeve
when connecting to the relative
battery terminal of the inventer.
1
1
7
8
9
3
3
6
2
2
4.1 Mounting the Screw Plugs
For better appearance, the top of the expanded battery needs to be locked with plastic screws and plastic covers.
Connect the cables between the batteries and route them from the rear side of the battery.
Disclaimer:
This Quick Installation Guide is not replacing Safety and Installation Instructions, it is a short introduction to the
product installation. The reference remains the Safety and Installation Instructions.
BAT -6
BAT +
BAT -
COM
GROUNDING
BAT -5 BAT -4 BAT -3
From BAT -1
to BAT -5
BAT -2 BAT -1
BAT -6 BAT -5 BAT -4 BAT -3 BAT -2 BAT -1
Remove
3.0 Commissioning
Switch ON:
Switch OFF:
Press 1 sec
OFF ON
1
2
2
3
4.0 Mounting the side Plates
3
4
5
√
1 2
*
*
*
*
*
*
*
*
**
≤3mm
M5x10 + PH2
2.5N.m
3. 4.
Position Designation
1 Housing
2 M5 terminal lug with protective conductor
3 M5x12 PH2 head screw
4 PE cable
2.6 Electrical Connection
2.6.1. Grounding
Refer to manual
1
2
3
4
PH2x150mm
2.5Nm
BAT+
BAT-
4
4
5
INV
BAT
1
2
3
4
1
2
3
M5x10 + PH2
2.5N.m
Press 5 sec
Lights are o
1
3
DANGER
CAUTION
CAUTION
NEED MORE HELP?
 Ifyouwouldliketocontactusdirectly,pleasevisitourocialwebsite:
https://sunpower.maxeon.com for more information.
Safety and Installation Instructions for SunPower Reserve