MB QUART QUBOne User manual

QUBOne
BluetoothTM Speaker

CONTENTS
Important Safety Instructions
Controls
Power Switch
Charging
Bluetooth Connection
Auxiliary Input
Receiving and Making Calls
Specications
Page 3
4
5
6
7-8
9
10
11

IMPORTANT SAFETY INSTRUCTIONS
• Read, follow and keep these instructions.
• Do not use this product near water or wet surfaces.
• Clean only with a dry cloth.
• Do not expose to extreme high or low temperatures.
• Only use the supplied cables for charging and playback.
3

CONTROLS
4
Power Switch
Rotate and hold: volume up\down
Rotate and release: track +\-
Push and release: play \ pause
Pairing LED

CHARGING
Thersttimeyouuse
your Bluetooth speaker,
please charge it for at
least 1.5 hours. During
therstcharge,donot
turn on the device.
Using the supplied USB cable
connect to a USB power source
(eg. a computer).
While charging, the yellow
LED on the rear of the unit will
illuminate.
When fully charged, the yellow
LED will turn off.
Aftertherstcharge,youcanplay
and charge at the same time.
5

BLUETOOTH CONNECTION
When the speaker is turned on, you should hear a voice prompt and the blue pairing LED
onthesideofthedevicewillashquicklyindicatingthatpairingmodeisactivatedandit
issearchingforaBluetoothsource.TheblueLEDwillashslowlywhenitisattemptingto
connect to the device it was paired to last.
Go to the Bluetooth menu of your source device and connect to QUBOne from the list of
devices. If asked for a code, enter 0000.
Oncetheconnectionisachieved,thepairingLEDwillstopashingandthespeakerwill
emit two short beeps.
You are now connected and can play from your source.
6

Make sure that no other source in range is connected. Only one connection can be made
at a time, The speaker may automatically connect to a source it has been paired with in the
past.
Turn off the speaker, then on again. Try pairing again.
Make sure the source is Bluetooth compatible and that the Bluetooth is activated.
Review your source device documentation for Bluetooth pairing instructions.
TROUBLE CONNECTING?
7

AUXILIARY INPUT CONNECTION
Insert the supplied 3.5mm cable
into the speaker’s AUX input. The
pairing LED will illuminate when
this connection is made.
Connect the other end to the
output of your source device.
You can now play your content.
The Bluetooth will be disabled
anytime a 3.5mm cable is inserted
into the AUX input.
8

RECEIVING AND MAKING CALLS
Your speaker will allow you to make hands free calls provided your phone is connected via Bluetooth.
The AUX connection cannot be used for this function.
To make a call: Use the phone as normal, select the Bluetooth speaker when prompted.
To receive a call: Either push the PLAY/PAUSE button on the side of the speaker or answer the call
with the phone making sure to select the Bluetooth speaker when prompted.
Ending a call: Either push the PLAY/PAUSE button on the side of the speaker or hang up using the
phone as you normally would.
9

SPECIFICATIONS
Active Drivers:
Passive Drivers:
AmplierPower:
FrequencyResponse:
Battery Type:
Battery Capacity:
1 x 40mm (1.57 Inches)
-
3.2 Watts
85Hz - 17KHz
Lithium-ion Polymer
850mAh
Play Time:
Recharge Time:
BluetoothProles:
Bluetooth Range:
Dimensions:
Weight:
3 to 5 Hours
1.5 Hours
HFP-A2DP/ARVCP
10 meters in open space
60 x 60 x 59 (mm)
280 grams
10