Medify Air MA-WM35 User manual

Technical Data:
Voltage:110-120 V AC 60 Hz
Rated power: 40W
Noise Level: ＜66 dB(A)
Unit dimension: 15.6”H x 23.2”W x 3.9”D
Unit weight: 13.6 lbs.
Read this manual before using.
Operate the unit according to the instructions provided.
Keep this for future reference.
Model：MA-WM35
Medify Air
1325 SW 30th Avenue
Deerfield Beach, FL 33442
888-258-1008
[e-mail]
www.medifyair.com

TABLE OF CONTENTS

In order to avoid damage to you, others or property,
follow the safety precautions.
If the power cord or unit is out of order,
contact Medify Customer Service immediately.
This is a 110v unit. It is NOT made
for 220v use. Plugging into a 220v
outlet will burn out the motor and
circuits and the unit will no longer
work. Only use with a 110v outlet
Turn off power immediately in case of any
of the following:
● Malfunction of any switch
● Circuit failure
● Abnormal heating of wires or plugs
●
Any other malfunction
Keep machine dry.
Do not use solvents like Benzene,
Alcohol or any flammable cleaners
to clean the air purifie
Only a soft clean cloth is to be used.
Product introduction
Air inlet
Air outlet
Air inlet
Air outlet
Front panel Pre-filter, HEPA filter
and Activated carbon
filter
purifier body
Front panel Pre-filter,HEPA
filter and Activated
carbon filter
Screw
Wall mount bracket
Tabletop Stand plugs
purifier body
Screw
Tabletop stand support
1.Safety Precautions
34
: Keep batteries away from children.
This product contains a lithium button/coin cell battery.
If a new or used lithium button/coin cell battery is swallowed or enters the body, it can cause severe
internal burns and can lead to death in as little as 2 hours. Keep battery compartment closed at all times.
If the battery compartment does not close securely, stop using the product, remove the batteries, and keep
them away from children.If you think batteries might have been swallowed or placed inside any part of the
body, seek immediatemedical attention. Make sure to dispose of this and all batteries properly.

Screw mounting hole
Screw mounting hole
Screw mounting hole
Screw mounting hole
Screw mounting hole
Screw mounting hole
Wall mount bracket
Tabletop Stand
Product configuration list
Purifier body 1pc Filter 1pc
User manual Warranty card Remote control Screw
Optional configuration
Tabletop Stand 1pc
Wall mount bracket 1pc
Tabletop stand plug 2pcs
Expansion
plug 4pcs
Self tapping
screw 4pcs
User
manual
Warranty
card
5 6

Product use
PM2.5 indicator
light
TVOC indicator
light
Fan speed
indicator light
Air quality
indicator light
Timer
Child-lock
lonizer
Reset
AUTO mode
Sleep mode
ON/OFF
Speed
PM2.5/Timer
display window
Press ON/OFF button and unit will turn on.
Machine starts to work in low speed.
Press the button again,machine stops and
is in standby mode.
1.ON/OFF
3.Timer mode
Press timer button and choose hour options:
1,2,3…24 or no timer.
4. Sleep mode
Press sleep button to enter into sleep mode, all
other indicators lights will turn off.Fan speed and
noise level will change to the lowest setting. After
10 seconds, the sleep indicator light goes out as
well.Press any key to exit sleep mode.
5. Child-lock function
In this mode,none of the function keys can be
used or changed.(Except the child lock function).
To turn on the child lock,hold the button down
for 3 to 5 seconds.To turn off the child lock
function,hold the button down for 30 to 45 seconds.
6.Auto mode
Press AUTO button, unit will sound and indicator
. The air purifier will choose
fan speed according to the air quality:
Excellent--Low fan speed
Good-------Middle fan speed
Poor--------High fan speed
Air quality Display window Indicator light color
Excellent 0-75 Blue
Good 76-150 Green
Poor Above 150 Red
7. Ionizer Mode
Ionizer is an On/Off function.You can choose to
leave it on or off at your discretion.When Ionizer
is on,the indicator light will be lit.
8.Filter reset
The indicator icon will become lit when filter
needs to be changed.Lift the front cover and
remove old filter from the unit.Remove plastic
packaging from the new filter before installing
into the air purifier. Place new filter into the air
purifier with tab at top of filter should be facing
you. Replace front cover back. After new filter is
installed and unit is turned back on. Hold down
the filter reset button for 3-5 seconds and the
indicator light will go off and timer is reset for
3000hours.
7 8
2. Manual adjustment of fan
Press speed button to choose your speed.
Options are: 1,2,3.
of Auto mode will be on
Make sure to unplug before changing filter
Remove all plastic packaging from filter
before installing.
Do Not run the air purifier when no filter
is installed.

9.Purification indicator
After power on, the purification indicator light remains on for a long time
10.Digital display window
Figure represents indoor PM2.5 or timer setting time (displays for 5 seconds)
11.Description of TVOC indicator light
Red: air quality is poor
Green: air quality is good
Blue: air quality is excellent
5.Inst al lati on g ui de
Des ktop
1.Install tabletop stand plug
Put 2 plugs into the tabletop stand
hole as shown in the figure
Tabletop stand plug Tabletop Stand
2.Install tabletop stand
Install the 3 bracket screw from the bracket
holes to the purifier body as shown in the
figure
Purifier body
Bracket screw
Bracket
Take off the front panel
Fasten the left and right sides of the
front panel, lift it slightly and take off the
front panel
Purifier body Front panel
Purifier body Front panel Filter
Cover the front panel
Take out filter, remove plastic packaging and
dispose of it properly
Take the handle on the left and right sides of the filter,
gently take it out from the purifier body,remove the
plastic packaging and dispose of it properly,and then put
9 10
the filter back into the purifier.

Wal l m o u n t ed
11 12
(66.9 inches away from the ground) remove wall
bracket form the package, hold wall bracket against
the wall, mark the position of the screw holes with a
pencil on your wall and remove wall bracket.
Installation of wall bracket
Drill 4 holes on the 4 pencil marks you just
made on wall. Insert the 4 rubber plugs into
the wall. Then hold wall bracket up and align
with the holes. Screw in the 4 self-tapping
screws.
0.47inch
6*1.57inch 6*1.57inch
Take out filter, remove plastic packaging
and dispose of it properly
Take the handle on the left and right sides of the filter,
gently take it out from the purifier body,remove the
plastic packaging and dispose of it properly,and then put
the filter back into the purifier.
Take off the front panel
Wall mount bracket
M4*0.47inch

13 14
2.True HE PA H13 Filter 4.Ionizer
such as: Dust, Dander, Hair
and others
HEPA H13 is a higher grade of
TRUE HEPA that can remove
microns as well as PM2.5
dust mites and others.
Fourth step:
Second step:True HEPA H13 Filter
positive particles.
Unplug air purifier before cleaning the unit.
Do not use excess water to clean the unit.
down unit. Do not use cleaners or chemicals
Cleaning Your Air Purifier
dust accumulate on the unit, wipe with
a clean dry cloth. Also make sure air
intake and vents are free from excess
dust. Do not vacuum or try and wash filter
as it will clog filter.
6.Filter Purification: Four Steps 7.Maintenance and Cleaning

15 16
8. Warranty and service
every six(6)months of after 3,000 hours of use.The filter replacement
will let you know when it is time to change.indicator
Medify Air
1325 SW 30th Avenue
Deerfield Beach, FL 33442
888-258-1008
Medify Air, 1325 SW 30th Avenue, Deerfield Beach, FL 33442.