Members Mark Charles GC-9067-5PC User manual

Charles 5pc Deep Seating set
Model Number: GC-9067-5PC
THIS ASSEMBLY MANUAL CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Assembly Manual

Important Safety Information
Please read all instructions carefully before assembling this furniture.
For your safety, assembly by two or more adults is strongly recommended.
Use only vendor-supplied hardware to assemble this item. Using unauthorized
hardware could jeopardize the structural integrity of the item.
Hardware may loosen overtime. Periodically check that all connections are tight.
Remove all parts and hardware from the box. Place all items on a carpeted or
scratch-free work surface, as this will avoid damaging parts during assembly.
The shipping box provides an ideal work surface.
To avoid accidentally discarding small parts or hardware, do not dispose of any
packaging or contents of the shipping carton until assembly is complete.
Use the parts and hardware lists below to identify and separate each of the
pieces included.
The use of power tools for assembly is not recommended. Power tools can
damage the hardware.
Note: Do not fully tighten all bolts until all parts are in place. Failure to follow
these instructions may cause the bolts to misalign during assembly.
Before Assembly
Dust often and use a vacuum cleaner crevice tool to clean seams. To maintain
the woven appearance, gently clean soiled areas with a soft cloth dampened
with a mild, water based detergent. Remove all lather and wipe with a clean
damp cloth. Dry with another soft cloth by blotting the damp surface (do not
rub).
Care and Cleaning

Components
A.......Table top.......1
B.......Table leg.......4
Hardware
(D)
M6x20mm Allen/Hex
Head Bolt
Qty: 12
(E)
M6 Washer
Qty: 12
(F)
Allen Wrench
Qty: 1
A
C..........Shelf..........1
B C
Need Assistance? Visit us at: samsclub.com/membersmarkhelp

Carefully place the table top (A) upside down on a non-abrasive surface.
Assemble the table legs (B) to the table top(A) with bolts (D) and washer (E) by using
Allen wrench (F).
Do not tighten the bolts until assembling is completed.
Step 1
(D)
M6x20mm
Allen/Hex Head Bolt
Qty: 12
(E)
M6 Washer
Qty: 12
(F)
Hex Wrench
Qty: 1
Need Assistance? Visit us at: samsclub.com/membersmarkhelp

Attach the shelf (C) to the table legs (B) using bolts (D) and washers (E)
with AllenWrench (F).
Tighten all bolts with Allen wrench.
Step 2
Need Assistance? Visit us at: samsclub.com/membersmarkhelp

Crefully turn the table over.
The side table is ready for your enjoyment.
Step 3
Need Assistance? Visit us at: samsclub.com/membersmarkhelp