Meraki Wall Plug User manual

Setup Guide
Meraki Wall Plug
1
Welcome.
Here is your Meraki Wall Plug.
Get started.
Meraki Wall Plug (US)
Faceplate screw, bracket & bracket screw
Meraki Wall Plug (EU)
2 brackets & 2 bracket screws
Ethernet cable is not included.
You may also need wall screws and anchors for a secure mount.
1. Plug it in.
US Plug EU Plug
32
Check signal strength using LEDs.
Signal strength
1 light: Fair
4 lights: Strongest
Moving lights:
Searching for signal
Flashing:
Weak signal
Recommended size for wall screws: Diameter Length
US Plug
EU Plug
A gateway is a Meraki repeater connected to the Internet.
Every Meraki network must have one or more gateways.
3. Create a gateway.2. Secure your unit.
Router or modemEthernet cable
Your Meraki Wall Plug has a range of about 150 feet (50 meters).
When installing a new Meraki Wall Plug as a repeater, you can check its
connection to the rest of the network using the signal strength LEDs.
4. Deploy your repeaters.
US #6 1inch
EU M3 25mm
Wall screws and anchors (not included)

4
Login to http://dashboard.meraki.com.
If this is your first time on Dashboard, create a new account.
Register all of your repeaters.
You will need your Meraki Order Number (found on your invoice) or
the MAC address and serial number of each repeater (found on the
back of each unit).
Place your repeaters on the map.
Select “Map View” and place each repeater on the map by clicking
and dragging it to the correct location.
5. Configure your network.
Congratulations.
You’re done!
5
6. Test your network.
Confirm that you have good signal strength throughout your
coverage area. You can use the signal strength meter on a laptop.
For more information, visit Meraki Support at http://meraki.com/help.
Repeaters
Gateway
Part Number: 280-07100
US – Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and if not installed and used in accordance with the instructions may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving device.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
EU – EN 55 022 Declaration of Conformance
This equipment is shielded against the generation of radio interference in
accordance with the application of Council Directive 89/336/EEC, Article 4a.
Conformity is declared by the application of EN 55 022 Class B (CISPR 22).
6
For more information, visit
http://meraki.com/collateral/product/meraki_wallplug_reg.pdf