D-Link D DWL-8200AP DWL-8200AP User manual

Quick Install Guide+
Руководство по быстрой установке+
Guía de instalación rápida+
Guia de instalação rápida+
快速安裝手冊+
Managed Dualband Access Point
DWL-8200AP

Install Guide
DWL-8200AP
Managed Dualband Access Point

3
Minimum System Requirements:
• CD-ROM Drive
• Computers with Windows®, Macintosh®, or Linux-based operating systems
• Installed Ethernet Adapter
• Internet Explorer version 6.0 or Netscape Navigator™version 7.0 and
above
System Requirements
Package Contents
Note: Using a power supply with a different voltage than the one included with the
DWL-8200AP will cause damage and void the warranty for this product.
If any of the above items are missing, please contact your reseller.
DWL-8200AP
Managed Dualband Access Point
Power over Ethernet base unit
Ethernet Cable
(CAT5 UTP/Straight Through)
CD-ROM
with Manual
Mounting Plate
Power Cord
Power Adapter-DC 48V, 0.4A

4
Installing the Hardware
Power Cord socket
LAN 1 (PoE)
Antennas
LAN 2
Reset

5
Step 1
Connect one end of an Ethernet cable (included with your package) to the
LAN 1 (PoE) port on the DWL-8200AP, and the other end of the Ethernet
cable to the port labeled P+DATA OUT on the PoE base unit.
Step 2
Connect another Ethernet cable from the DATA IN port on the PoE base
unit to your router/switch or to a PC.
Step 3
Attach the power adapter to the connector labeled POWER IN on the PoE
base unit. Attach the power cord to the power adapter and into an electrical
outlet.
DWL-8200AP
Computer
(Straight Through Cable)
Router or Switch
(Straight Through Cable)
Step2
Step1
Line1(PoE)
Step3
P+DATA
OUT
DATA
IN

6
Step 1: Insert provided wall anchors in the wall where the mounting plate will
be attached.
Mounting Plate Assembly
Step 2: Use the provided screws to secure the mounting plate on the wall.

7
Step 3: Attach the remaining screws securely to the back of the
DWL-8200AP.
Step 4: Attach the DWL-8200AP to the mounting plate.

8
Step 5: Slide the DWL-8200AP down into the grooves on the mounting plate to
secure it to the plate.

9
When you have completed the steps in this Installation Guide and congured
your for your network, your network should look similar to this:
Your Setup is Complete
* Maximum Wireless signal rate derived from IEEE Standard 802.11a and 802.11g specications.
Actual data throughput will vary. Network conditions and environmental factors, including volume
of network trafc, building materials and construction, and network overhead lower actual data
throughput rate.

Technical Support
You can nd software updates and user documentation on the
D-Link website.
Tech Support for customers within Australia:
D-Link Technical Support over the Telephone:
1300-766-868
Monday to Friday 8:00am to 8:00pm EST
Saturday 9:00am to 1:00pm EST
D-Link Technical Support over the Internet:
http://www.dlink.com.au
email:[email protected]
Tech Support for customers within New
Zealand:
D-Link Technical Support over the Telephone:
0800-900-900
Monday to Friday 8:30am to 8:30pm
Saturday 9:00am to 5:00pm
D-Link Technical Support over the Internet:
http://www.dlink.co.nz
email:[email protected]