Merck EMD Serono easypod User manual

EASYPOD®HOW TO...
CHANGE THE DOSE
Dose settings
Clinical settings
Injection settings
Regional settings
Dose log
Connection
Change Back
Remove cartridge
Menu
Device settings
Clinical settings
Teach me
Data transfer
Open Exit
Power on the
easypod device,
then press the
MENU button on
the main screen.
Choose INPUT IN MG,
then press OK.
Press OK to the
warning message.
Enter PIN code 0000 by
using the arrow key to
select 0and press OK.
Repeat until you see
0000, then press OK.
Use the arrow
key to move
down and choose
CLINICAL SETTINGS,
then press OPEN.
Change the dose using
the arrow buttons and
press OK after each change.
Confirm frequency, then
press OK. Confirm dose,
then press OK.
Dose adjustment:
Press OK.
If dose adjustment was OFF, after
pressing OK you will see a screen
asking you to confirm daily dose.
If dose adjustment was ON, after
pressing OK you will see a dose
spread screen with <10% or <25%.
Ensure the correct value is highlighted
in white, then press OK. Once the
screen displays minimum and
maximum dose spread, press OK.
Select DOSE
SETTINGS,
then press CHANGE.
Always check that the dose is correct at the top of the easypod main screen.
1 5
2
6
7
8
3
4
The dose has now been
updated and you are back
in the Clinical Settings menu.
If you do not need to make
any other changes, press
BACK again, then press EXIT
to return to the main screen.

easypod®is a registered trademark of Merck KGaA. All rights reserved.
© 2020 EMD Serono, a division of EMD Inc., Canada, a business of Merck KGaA, Darmstadt, Germany.
For complete information refer to the
easypod Instructions for Use.