Crosswater US-ARC953 User manual

Installation Instructions
Adjustable
wrench
Channel
locks
Plumbers’ putty
or caulking
Flat head
screwdriver
Cross head
screwdriver
Hexagonal
key
Wall Outlets
US-ARC953
US-WF953
US-WL952
US-WL953
Introduction
Installation notes
The walloutlet has been fully inspected throughout the production
process and only leaves our factory after a 15-step QC process.
Carefully remove the wall outlet from the box andcheck that all parts
have been supplied.
Before beginning installation, please check for any damage that may
have occurred during transport. Note: Damage claims cannot be
made during or after installation.
Improper installation shall result in loss of warranty in case of
damage caused by impacts or rubbing against rough surfaces.
Prior to installing the wall outlet,prepare a connection of water
inlet/outlet.
IMPORTANT: Please read these instructions carefully before
beginning and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
Dimensions
Tools required
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
IMPORTANT! Before installing a new wall outlet it is essential that the
supply pipes are thoroughly flushed in order to remove any remaining
debris, solder or other impurities. Failure to carry out this simple
procedure can cause problems or damage to the working of the
wall outlet.
Installing shut-off valves on incoming supply lines is recommended
for ease of maintenance.
Turn off the main water supply before connecting to any existing
pipework or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise, before drilling holes in a wall or floor.
US-ARC953 US-WL952
2" x
G1/2"
1-1/4"
1-1/4"
1/2-14 NPT
1/2-14 NPT
1-1/4"
Ø2-3/8"
2"
G1/2"
1/2"
1/2"
2"
US-WL953
G1/2"
Ø2-1/4"
1-1/4"
7/8"
Ø1-1/8"
1-7/8"
1/2-14 NPT
1/2"
1/2-14NPT
2"
2-3/8"
1-1/4"
G1/2"
2-1/8"
US-WF953

BASE
Shut off the water heating system then, with the main water
supply turned off, open the lowest hot and cold faucets and allow
to drain until supply pipes are empty.


water feed as shown opposite.
ATTENTION: Check all new connections for leaks.
Turn on the main water supply, close all faucets except for the new

Installation
Parts list
wall outlet
G1/2
1/2-14 NPT
G1/2
1/2-14 NPT
G1/2
1/2-14 NPT
CONNECTOR
CHECK VALVE
WASHER
BASE
SCREW
CONNECTOR
O-RING
CONNECTOR
CHECK VALVE
WASHER
BASE
CONNECTOR
O-RING
CONNECTOR
CHECK VALVE
WASHER
US-ARC953 US-WL952
US-WL953
US-ARC953 US-WL952
US-WL953
supply.
US-WF953
BASE
CONNECTOR
CHECK VALVE
WASHER
US-WF953

3 Cleaning Instructions
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any
overspray. This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup.
Follow instructions to ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners, cleansers or
disinfectants will alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass
cleaners to remain on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.
Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757 crosswaterlondon.com
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone] email: [email protected]
Issue date: 15092019