Metra Electronics 95-7321 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-7321
1-800-221-0932 www.metraonline.com
KIT FEATURES
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION
• DDIN Head Unit Provision
• ISO Stacked Head Unit Provision
A) DDIN Brackets B) DDIN Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
95-7321
A
APPLICATIONS
Hyundai Accent 2006-2010
Kia Rio / RIO 5 2006-2010
Kia Sportage 2005-2010
B
Phillips Screwdriver • Small Flat Blade Screwdriver • Panel Removal Tool • Cutting Tool
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
HARNESS:
ANTENNA ADAPTER:
• 70-7303 - Hyundai / Kia Harness 2009
• 70-1004 - Hyundai 2006-up/KIA harness 2004-up
• 40-KI11 - KIA antenna adapter 2007-up
• 40-KI10 - KIA antenna adapter 2007-up
METRA. THE WORLD’S BEST KITS.™

Dash Disassembly ........................................................................ 1-2
Kit Preparation ................................................................................. 3
Kit Assembly ..................................................................................... 4
95-7321
TABLE OF CONTENTS
Metra recommends MECP certified
technicians

95-7321 DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Unclip and remove the trim panel
surrounding the radio and including
the a/c vents.
(Figure A)
2
HYUNDAI ACCENT 2006-2010
KIA RIO / RIO 5 2006-2010
Remove (4) Phillips screws securing
the radio.
(Figure B)
3
A
B
1

95-7321 DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Unclip and remove the entire panel
surrounding the radio and including
the A/C controls. Note: Start at
bottom of panel.
(Figure A)
2
KIA SPORTAGE 2005-2010
Remove (4) Phillips screws to extract
radio from dash.
(Figure B)
3
A
B
2

3
HYUNDAI ACCENT: Cut and remove
shaded areas. (Figure A)
1
A
KIA RIO: Cut and remove shaded
areas.
(Figure B)
2
KIA SPORTAGE: Cut and remove
shaded areas. (Figure C)
3
B
B
95-7321
KIT PREPARATION

4
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the unit for proper operation.
1
A
Attach the Double DIN brackets to
the inside edge of the Double DIN
trim plate. (Figure A)
2
Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly and
secure the Double DIN head unit or
stacked ISO head units to the
assembly using the screws supplied
with the radio. (Figure B)
3
Reassemble dash in reverse order of
disassembly.
4
DOUBLE DIN / STACKED ISO DIN
HEAD UNIT PROVISION
B
95-7321
KIT ASSEMBLY

95-7321
NOTES

95-7321 INSTRUCTIONS
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST95-7321
REV. 04/26/10
METRA. THE WORLD’S BEST KITS.™