Metra Electronics 99-8216 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-8216
1-800-221-0932 www.metraonline.com
KIT FEATURES
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
• DIN Radio Provision with pocket
• ISO Radio Provision with pocket
A) Radio Housing B) Housing Brackets-3 Door C) Housing Brackets-4 Door D) ISO Snap In Brackets E) Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
99-8216
APPLICATIONS
Phillips Screwdriver • Socket Wrench •
Small Flat Blade Screwdriver or
Panel Removal Tool
D
E
Toyota
Yaris
2007-2010
(Excludes models equipped with power package)
A
B
C
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wire harness:
• 70-1761 Toyota 1987-up
• TYTO-01 Toyota amp interface harness 2003-up
Antenna adapter:
• Not required

TABLE OF CONTENTS
99-8216
Dash Disassembly
Yaris 2007-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Kit Assembly
Din Mount Radio Provision with pocket. . . . . . . . . . . . . . . . . . 2
ISO Mount Radio Provision with pocket. . . . . . . . . . . . . . . . . . 3
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
K NOWLEDGE IS P OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take
steps toward a better tomorrow.

99-8216
1
DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Unclip the bottom trim panel located
underneath the A/C Controls.
Figure A)
2
YARIS 2007-2010
Unclip the two side trim panels that
surround the A/C Controls and Radio.
(Figure A)
3
Unclip the Instrument trim Panel
surrounding the Speedometer and
gauges.
(Figure B)
4
Unclip the Radio/AC Vents trim
Panel.
(Figure B)
5
Remove (4) Phillips screws securing
radio. (Figure C)
6
Continue to kit assembly.
7
A
B
C
Unplug and remove radio.

99-8216
KIT ASSEMBLY
2
Slide the Mounting Brackets onto the
sides of the Radio Housing until the
side clips engage. Note: Tabs are
marked 8216-3L and R for the 3
door Yaris and 8216-4L and R for the
4 door Yaris. (Figure A)
1
A
DIN MOUNT RADIO PROVISION
NOTE: Refer also to the instructions
included with the aftermarket radio.
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs outward.
(Figure B)
2
Slide the aftermarket radio into the
cage until it snaps into place.
(Figure C)
3
Continue to final assembly.
B
C

3
99-8216
KIT ASSEMBLY
Slide the Mounting Brackets onto the
sides of the Radio Housing until the
side clips engage. Note: Tabs are
marked 8216-3L and R for the 3
door Yaris and 8216-4L and R for the
4 door Yaris. (Figure A)
1
A
ISO MOUNT RADIO PROVISION
NOTE: Refer also to the instructions
included with the aftermarket radio.
Mount the ISO Brackets to the
aftermarket radio using the screws
supplied with the radio. (Figure B)
2
Slide the radio into the radio opening
until the side clips snap into place.
(Figure C)
3
Continue to final assembly.
B
C
Snap the Trim plate onto the front the
Radio Housing assembly. (Figure C)
4

4
FINAL ASSEMBLY
1
Locate the factory wiring harness in the dash and make the connection as shown.
Metra recommends using the proper mating adapter and making the connections
as shown. (Isolate and individually tape off the ends of any unused wires to pre-
vent electrical short circuit.)
2
Re-connect the negative battery terminal and test the unit for proper operation.
3
Reassemble radio and dash assemblies in reverse order of disassembly.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D
Make wiring connections using the EIA color code chart shown below and the instructions included with the head
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually
tape off ends of any unused wires to prevent electrical short circuit.
12V Ignition / Acc . . . Red
12V Batt / Memory . . Yellow
Ground . . . . . . . . . . . Black*
Power Antenna . . . . . Blue
Amp Turn-On . . . . . . Blue / White
Amp Ground . . . . . . . Black / White
Illumination. . . . . . . . Orange
Dimmer . . . . . . . . . . Orange / White
Right Front (+) . . . . . Gray
Right Front (-) . . . . . . Gray / Black
Left Front (+) . . . . . . White
Left Front (-) . . . . . . . White / Black
Right Rear (+). . . . . . Violet
Right Rear (-) . . . . . . Violet / Black
Left Rear (+). . . . . . . Green
Left Rear (-) . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
METRA / EIA WIRING CODE
FINAL WIRING CONNECTIONS
99-8216
FINAL ASSEMBLY

5
99-8216
NOTES

99-8216 INSTRUCTIONS
1-800-221-0932 www.metraonline.com
REV. 04/26/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-8216