Metra Electronics 95-8223 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-8223
APPLICATIONS
Toyota Corolla
2009
-10
KIT FEATURES
•Double DIN Radio Provision
•Stacked ISO Mount Units Provision
•Painted ToMatch Factory Dash
95-8223= BLACK
95-8223S= SILVER
•A) Radio Housing Trim Plate • B) Double Din Trim Plate
Harness & Antenna Connections (sold separately)
•70-1761 Toyota Harness 87-up
•TYTO-01 Toyota Amp Interface 03-up
KIT COMPONENTS
B
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
•Phillips Screwdriver
1-800-221-0932
©COPYRIGHT 2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
A
95-8223/
95-8223S

Dash Disassembly
- Toyota Corolla 2009-10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Kit Assembly
-Double DIN/Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . 2
Final Assembly ...........................................3
TABLE OF CONTENTS
95-8223
*Note:
Refer also to the instructions included with the aftermarket radio.
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skillsby
enrolling in the most recognizedandrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake steps
toward abetter tomorrow.

95-8223 DASH DISASSEMBLY
Toyota Corolla 2009-10
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the (4) side trim
panels from the right and left side of
the radio and a/c controls. ( Figure A)
2
Unclip and remove the a/c vent panel
above the factory radio. (Figure B)
3
Remove (4) 10 MM bolts securing the
radio. (Figure C)
4
Remove (4) plastic clips from the
back of the factory radio. (Retain the
clips for re-use during kit assembly.)
6
Remove (8) screws securing the
brackets to the factoryradio and
remove the brackets. (Retain the
brackets for re-use during kit
assembly.)
(Figure D)
5
Continue to kit assembly.
A
B
C
D
REMOVE (4) SCREWS
FROM FACTORY BRACKET FROM EACH SIDE

95-8223 KIT ASSEMBLY
2
A
B
DOUBLE DIN/STACKED ISO MOUNT UNITS PROVISION
Attach the factory mounting brackets
and the Double DIN trim plates to the
Double DIN or the stacked ISO mount
unit(s) using the screws supplied with
the unit(s).
(Figure B)
2
Attach the clips removed from the
factory radio to the back of the radio
housing trim plate. (Figure A)
1
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.

95-8223 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble in reverse order of disassembly using the 95-8223 Radio Housing
Trim Plate in place of the factory radio trim panel.
1
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown belowand the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc..........Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
3

95-8223
NOTES
4

95-8223
NOTES
5

95-8223 INSTRUCTIONS
1-800-221-0932
REV.04/29/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST95-8223
www.metraonline.com