Metra Electronics 99-7415 User manual

KIT COMPONENTS
99-7415
INSTALLATION
INSTRUCTIONS
KIT FEATURES
DIN head
unit provisions
Radio Housing
TOOLS REQUIRED
Phillips screwdriver

Disconnect the negative battery terminal to prevent an accidental short circuit. Open the
ashtray/cupholder assembly, depress the retaining clips on each side and remove the
assembly. Remove (2) Phillips screws from each side of the ashtray/cupholder assembly.
Remove (4) plastic rivets from the lower pocket and slide the pocket back. (NOTE: It is NOT
necessary to remove the pocket. Unclip the dash trim bezel and remove. Remove (4) Phillips
screws securing the factory head unit and disconnect the wiring.
1
2
ALL VEHICLES
5
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) Phillips screws previously removed in step #1.
4
3
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the (4) mounting positions in the sub-dash
("A").
Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down.
Slide the aftermarket head unit into the DIN cage until secure.
"A"
METRA ACCESSORIES STEREO DASH KITS