Metra Electronics 95-3302 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-3302
95-3302
APPLICATIONS
GM
MULTI KIT
(
see models list inside)
KIT FEATURES
•Double DIN Mount Radio Provision
•Stacked ISO Mount Radio Provision
• Painted To Match Factory Dash
A) Double DIN Housing • B) Double DIN Brackets
KIT COMPONENTS
A
B
Small Flat Blade Screwdriver/ Panel Removal Tool
•Phillips Screwdriver • Socket Set • Cutting Tool
1-800-221-0932
©COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS REQUIRED:
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
•See www.metraonline.com for specific interface applications
Antenna Adapter:
• 40-GM10 - GM antenna adapter 1988-up
•40-CR10 - Chrysler antenna adapter 2002-up

Dash Disassembly
Chevrolet
- Cobalt 2005-2010 . . . . . . . . . . . . . . . .1
- Equinox 2005-2006 . . . . . . . . . . . . . 2
-HHR 2006-2010. . . . . . .. . . . . . . . . . . . 3
- Malibu 2004-2007 . . . . . . . . . . .....4,5
- Malibu 2008-2010 . . . . . . . . . . . .....6
Pontiac
- G5 2007-2009 ................... .1
- G62005-2009.................. .. 7
- Solstice 2006-2009 . . . . . . . . . . . ... .8
- Torrent2006.................... .. 2
TABLE OF CONTENTS
95-3302
Note: (Cobalt and G5 2005-2006)
Toretain Onstar use 99-3303 instead.
Note: (Malibuand G6 only)
•The Driver Information Center and radio are one unit. Removal of the radio
will prohibit the vehicle owner from programming anyof the features of the
Driver Information Center. However once the features are programmed the
vehicle will retain all the settings. An alternative kit 99-3303 inludes a
replacement driver information center with programming capabilities.
The 99-3303 does not allow for Double DIN installations.
•Refer also to the instructions included with the aftermarket radio.
Saturn
- Aura 2007-2009 . . . . . . . . . . . . . . . . . .9
- Ion 2006-2007 . . . . . . . . . . . . . . . ....10
- Sky 2006-2009 . . . . . . . . . . . . . . . . . ..11
-Vue 2006-2007 ................ ...12
Kit Assembly
Double DIN Mount Radio Provision .................................................13
Stacked ISO Mount Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Final Assembly .................................................................15
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skills
by enrolling inthe most recognized and
respected mobile electronics school in our
industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake
steps towardabetter tomorrow.

95-3302 DASH DISASSEMBLY
Chevrolet Cobalt 2005-2010/Pontiac G5 2007-09
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove trim panel from
above glove box. (Figure A)
2
Unclip upper edge of panel below
steering column and let hang. Not
necessary to remove completely.
(FigureB)
3
Unclip and remove small trim panel to
right of ignition switch. (Figure C)
4
Unclip and remove trim panel sur-
rounding radio and climate controls.
(Figure D)
5
Remove (4) 9/32 screws securing
radio.Unplug and remove the radio.
(FigureE)
6
Continue to kit assembly.
A
B
C
DE
1

2
95-3302 DASH DISASSEMBLY
Chevrolet Equinox 2005-2006
Pontiac Torrent 2006
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unsnap panel below power window
switch and remove. Note: This
allows you to unplug the window
switch easier. (Figure A)
2
Unsnap and remove entire panel sur-
rounding radio and shifter. (Figure B)
3
Remove (4) 9/32 screws securing
radio.Unplug and remove the radio.
(FigureC)
4
Continue to kit assembly.
A
B
C

3
95-3302 DASH DISASSEMBLY
Chevrolet HHR 2006-2010
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove entire panel sur-
rounding radio and a/c controls
including the a/c vents. (Figure A)
2
Remove (8) 9/32” screws securing
radio and a/c control to remove
radio. (Figure B)
3
Continue to kit assembly.
A
B

4
95-3302 DASH DISASSEMBLY
Chevrolet Malibu 2004-2007
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove wood grain/paint-
ed trim pieces from both sides of
steering wheel. (Figure A)
2
Unclip and remove side panel from
driver’s side of dash with door open
and remove (2) 7 MM screws.
(Figure B)
3
Remove (2) 7 MM screws from bot-
tom edge of panel below steering
wheel, unclip panel and let hang.It
is not necessary to completely
remove panel. (Figure C)
4
Unclip and remove wood
grain/painted trim piece from above
glove box. (Figure D)
5
A
B
C
D

5
95-3302 DASH DISASSEMBLY
Chevrolet Malibu 2004-2007
Remove (2) 7 MM screws from bot-
tom of glove box then open box and
squeeze sides together to open fur-
ther and remove the remaining (4)
7MM screws. Unclip the black vent
cover under the glove box then unclip
and remove entire glove box assem-
bly. (FigureF)
7
Unclip and remove trim panel sur-
rounding radio and climate controls.
(Figure G)
8
Remove (4) 7 MM screws securing
the radio and (2) 7 MM screws secur-
ing the climate control. Unplug and
remove the radio. (Figure H)
9
Continue to kit assembly.
F
E
G
H
Unclip and remove side panel from
passenger side of dash with door
open and remove (2) 7 MM screws
from behind panel. (Figure E)
6

6
95-3302 DASH DISASSEMBLY
Chevrolet Malibu 2008-2010
Remove (2) 8 mm screws from
bottom of radio/climate panel.
3
Remove (6) 8 mm screws from
radio and climate controls.
5
Unsnap and remove the climate/radio
panel and upper vent trim panel
together.(They can be separated after
removel) (Figure B,C)
4
Continue to kit assembly.
Unsnap and remove shifter trim.
Note –start around shifter and be
sureto pull down before back
because this panel slides up
under the radio/climate panels.
(Figure A)
2
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
A
B
C

7
95-3302 DASH DISASSEMBLY
Pontiac G6 2005-2009
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Open glove box and remove (6)
screws from outer edge then unclip
and remove box. (Figure A)
2
Remove (4) screws from panel
below steering column. Unclip and
remove panel. (Figure B)
3
Unclip and remove center panel sur-
rounding radio and A/C controls.
(FigureC)
4
Remove (4) screws securing the radio.
Unplug and remove the radio.
(Figure D)
5
Continue to kit assembly.
B
A
C
D

8
95-3302 DASH DISASSEMBLY
Pontiac Solstice 2006-2009
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
A. Lift up the lower edge of the
instrument panel cluster trim plate
enough to reach underneath and
release the shift boot trim ring
retaining tabs. (Figure A)
B. Lift up on the shift boot and
loosen the setscrew to release the
shift lever. (Figure B)
2
A. Unclip and remove shifter trim ring.
(FigureC)
Unclip and remove passenger assist
handle trim panel. (FigureD)
3
Remove (2) bolts securing the pas-
senger assist handle and remove
handle. (Figure D)
4
Unclip and remove dash trim panel.
5
Remove (4) screws securing the radio.
Unplug and remove the radio.
6
Continue to kit assembly.
Manual transmission:
2
Automatic transmission:
A
B
C
D