Metra Electronics 95-3528 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-3528
95-3528
KIT FEATURES
•Double DIN Radio Provision
•Stacked ISO Mount Units Provision
A) Double DIN Brackets • B) Double DIN Trim plate
KIT COMPONENTS
A
Small Flat Blade Screwdriver • Panel Removal Tool
•86-3528 Radio Removal Keys
1-800-221-0932
©COPYRIGHT 2008 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS REQUIRED:
APPLICATIONS
PONTIAC GTO
2004-2006
B

Dash Disassembly
-PontiacGTO2004-2006.........................................1,2
Kit Assembly
-DoubleDINRadioProvision................... ....................3
-Stacked ISO Mount Units Provision . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . 4
Final Assembly ..........................................5
TABLE OF CONTENTS
95-3528
*Note:
Refer also to the instructions included with the aftermarket radio.

95-3528 DASH DISASSEMBLY
PONTIAC GTO 2004-2006
A
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Using the radio removal keys, pull the
factory radio from the dash and dis-
connect the wiring. (Figure A)
2
Remove (1) Phillips screw from inside
lower open storage area where
center console and dash meet.
(Figure C)
4
5
Unsnap and remove center console
(open center armrest/ storage com-
partment and work forward).
(Figure D)
3
Continue on page 2.
C
D
B
Unsnap and remove the trim panel at
the top center of the dash above the
A/C vents and remove (4) Phillips
screws. (Figure B)

95-3528 DASH DISASSEMBLY
PONTIAC GTO 2004-2006
E
2
Remove (2) Phillips screws exposed
at the bottom of the center panel sur-
rounding radio and remove panel.
(Figure E)
6
Unclip and remove trim panel sur-
rounding radio and A/C controls.
7
Pull down on the "cage" from the
opening inside on the top and
remove. (Figure G)
9
8
Continue to final assembly.
G
F
Remove (3) Phillips screws holding
"cage" in radio opening. (Figure F)

3
95-3528 KIT ASSEMBLY
A
DOUBLE DIN RADIO PROVISION
Attach the Double DIN brackets to the
Double DIN radio unit using the screws
supplied with the radio.
(Figure A)
1
*Note: Refer also to the instructions included with the aftermarket radio.
Continue to final assembly.

4
95-3528 KIT ASSEMBLY
A
STACKED ISO MOUNT UNITS PROVISION
Attach the Double DIN brackets to the
stacked ISO mount units using the
screws supplied with the units.
(Figure A)
1
*Note: Refer also to the instructions included with the aftermarket radio.
Continue to final assembly.

95-3528 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Snap the Double DIN trim plate onto the bracket/radio assembly.
1
2
4
Reassemble in reverse order of disassembly.
5
Insert and secure the radio/bracket assembly into the radio opening using the
screws removed in step 8 of disassembly.
3
5
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown belowand the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of anyunused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer.................Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) ..............Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.

95-3528 INSTRUCTIONS
1-800-221-0932
REV. 05/07/08 © COPYRIGHT 2008 METRA ELECTRONICS CORPORATION INST95-3528
www.metraonline.com