Metra Electronics 99-7009 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-7009
Phillips Screwdriver I Socket Wrench
1-800-221-0932 www.metraonline.com
KIT FEATURES
© COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION
APPLICATIONS
2004-2007 Mitsubishi Endeavor
• DIN Head Unit Provisions
• ISO DIN Head Unit Provisions
A) Radio Housing I B) ISO Brackets I C) Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
99-7009
A
B
C

99-7009
• Dash Disassembly
- 2004-2007 Mitsubishi Endeavor---------------------------------- 1
• Kit Assembly
- ISO Head Unit Provision with Pocket ---------------------------- 2
- DIN Head Unit Provision with Pocket ---------------------------- 3
• Final Assembly ------------------------------------------------------ 4
• Notes ---------------------------------------------------------------- 5
TSTNETN
OC
FO
EL
BA

99-7009
1
A
DY
L
B
ME
S
S
AS
ID
H
S
2004-2007 MITSUBISHI ENDEAVOR
Disconnect the negative battery terminal
to prevent an accidental short circuit.
Unsnap and remove entire panel sur-
rounding radio and A/C controls.
(Figure A)
1
2
Remove (1) 10MM nut from the rear support
on the top left of radio on cross bar behind
dash. (FIGURE B)
3
Remove (3) Phillips screws to remove
factory radio chassis (Figure C)
4
A
Remove (4) Phillips screws from the pock-
et at the bottom of the radio and A/C panel
and remove the pocket. (This is where the
99-7009 will be mounted.) (Figure D)
5
B
C
D

99-7009
2
KIT ASSEMBLY
DIN Head Unit Provision
1Slide the DIN cage into the Radio
Housing and secure by bending
the metal locking tabs down.
2Slide the after-market head unit
into the cage and secure. Snap
trim plate into the radio housing.
Using the factory hardware, mount
the 99-7009 in the location where
the factory pocket resided.

99-7009
3
YL
B
M
E
S
S
A
T
I
K
ISO DIN HEAD UNIT PROVISION
1Mount the ISO Brackets to the head
unit with the screws supplied with
the unit.
2Slide the head unit into the radio
opening until the side clips engage.
3Snap the Trim plate into the Radio
Housing.

99-7009
4
Y
L
B
M
ESS
A LAN
IF
A
Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter and making the connections as
shown. (Isolate and individually tape off the
ends of any unused wires to prevent electrical
short circuit) See figure A.
Re-connect the negative battery terminal and test
the unit for proper operation.
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
1
2
Reassemble radio and dash assemblies in
reverse order of disassembly.
3
B
C
D

99-7009
5
NOTES

INST997009
1-800-221-0932 www.metraonline.com
Rev. 06-14-07 © COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION INST99-7009