Metra Electronics 95-8903S User manual

METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
APPLICATIONS
1-800-221-0932 metraonline.com
INSTALLATION INSTRUCTIONS FOR PART 95-8903S
Subaru Legacy & Outback 2010-up
(Non-navigation radios only)
95-8903S
• DDIN radio provision
• Stacked ISO radio provision
• Painted silver
Panel Removal Tool • Phillips Screwdriver • Socket Wrench • Small Flat Blade Screwdriver
AB
• A) DDIN Trim plate • B) DDIN Brackets
TOOLS REQUIRED
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70-8901 Subaru Harness 1990-Up
• 70-7552 Nissan Harness 2007-Up
Antenna Adapter:
• 40-SB10 Subaru Antenna Adapter 2005-Up

Table of Contents
Dash Disassembly
– 2010-up Subaru Legacy 3
Kit Assembly
– Double DIN/Stacked ISO DIN Head Unit Provision 4
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
95-8903S
Caution
Metra recommends disconnecting the negative battery terminal before beginning any
installation. All accessories, switches, and especially air bag indicator lights must be
plugged in before reconnecting the battery or cycling the ignition.
*NOTE: Refer also to the instructions included with the aftermarket radio.

1. Disconnect the negative battery
terminal to prevent an accidental
short circuit.
2. Unclip and remove the radio trim panel
including the a/c vents. (Figure A)
3. Remove (4) Phillips screws securing the
factory radio.
Continued to kit assembly
3
Dash Disassembly
95-8903S
(Figure A)

4
Kit Assembly 95-8903S
1. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Attach the Double DIN brackets to the
Double DIN trim plate. (Figure A)
3. Slide the Double DIN head unit or
stacked ISO head units into the bracket/
radio housing assembly and secure
the Double DIN head unit or stacked
ISO head units to the assembly using
the screws supplied with the radio.
(Figure B)
4. Reassemble dash in reverse order
of disassembly.
Double DIN/Stacked ISO DIN head
unit provisions
(Figure A)
(Figure B)

Notes

Notes

Notes

METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932 metraonline.com
INSTALLATION INSTRUCTIONS FOR PART 95-8903S
REV. 7/27/11