Metra Electronics 99-7410 User manual

99-7410
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
NISSAN
200SX 1995-98........................................................1-3
Sentra 1995-99........................................................1-3
KIT COMPONENTS
TOOLS REQUIRED
Cutting tool
Adjustable wrench
Phillips screwdriver
Spacer
Snap Spacers
Equalizer
Dummy Plate
Radio Housing
KIT FEATURES
Shaft and
DIN unit
provisions
Equalizer
provisions
5 6
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) Phillips screws
previously removed in step #1.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
4
"A"
"A" "B"
"B"
Mount the factory cupholder to the bottom of the Radio Housing with (2) Phillips screws
previously removed in step #1 ("A") and (2) locating pins ("B").
3
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 250701

Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the
dummy plate from the center of the switch panel (above the radio opening). Unclip the radio
trim bezel and remove. Remove (4) Phillips screws securing the factory head unit and
disconnect the wiring. Remove (2) Phillips screws securing the factory cupholder and remove.
1
12
2-SHAFT HEAD UNITS: Attach the Spacer* to the Radio Housing. Slide the aftermarket
head unit into the mounted kit and secure with shaft nuts. (see Fig. A)
the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see
Fig. A). For an intermediate-mount installation, cut and remove the shaft supports from the
Radio Housing. Attach the Snap Spacers to the inner walls of the radio opening. Slide the
DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket
head unit into the cage until secure. (see Fig. B). For a flush-mount installation, cut and
remove the shaft supports from the Radio Housing. Slide the DIN cage into the kit and secure
by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until
secure. (see Fig. C)
DIN HEAD UNITS: For a
surface-mount installation,
cut and remove the shaft
supports from the Spacer*
and Radio Housing. Place
the Spacer into the Housing.
Slide the DIN cage into the
kit and secure by bending
ALL VEHICLES
2a
2b
3
*OPTIONAL
Fig. A
IF AN EQUALIZER WILL BE INCLUDED: Slide the aftermarket equalizer into the back of the
Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit.
(see Fig. A)
IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the
Radio Housing. (see Fig. B)
*OPTIONAL
*OPTIONAL
Fig. B
Fig. C
Fig. A
Fig. A
Fig. B