Metra Electronics 89-9400 User manual

INSTALLATION INSTRUCTIONS FOR PART 89-9400
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION
KIT FEATURES
APPLICATIONS
LAND ROVER
Discovery / Discovery II 1994-2004
DIN Head unit provision
A) Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
89-9400
A
86-9001 Radio Removal Tool
9E
TABLE OF CONTENTS:
Dash Disassembly ................ 1
Kit Assembly .......................... 2
Final Assembly ...................... 3

89-9400
DASH DISASSEMBLY
LAND ROVER DISCOVERY AND DISCOVERY II
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
2
A
Insert the long ends of the
86-9001 into the slots on the
factory radio and pull out to
remove. (Figure A)
1

KIT ASSEMBLY
89-9400
2
1
Snap the 89-9400 trim plate
into the bottom of the sub-
dash opening.
(Figure A)
2
Slide the DIN cage into the
space above the 89-9400 and
secure by bending the metal
locking tabs outward.
(Figure B)
3
Slide the aftermarket head
unit into the DIN cage until
secure.
A
B

3
FINAL ASSEMBLY
89-9400
1
Locate the factory wiring har-
ness in the dash. Metra recom-
mends using the proper mating
adapter and making the con-
nections as shown. (Isolate and
individually tape off the ends of
any unused wires to prevent
electrical short circuit)
2
Re-connect the negative battery
terminal and test the unit for
proper operation.
3
Reassemble radio and dash
assemblies in reverse order of
disassembly.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D