Silca AIR4Q User manual

Copyright by Silca S.p.A. - All Rights Reserved
COPY FIXED CODE REMOTES
with AIR4 Q
1
PLACE THE REMOTE CONTROL TO BE CLONED PERPENDICULARLY, IN THE LOWER LEFT SIDE OF THE AIR4
2
PRESS BUTTON 1 ON THE AIR4
REMOTE CONTROL
3
AT THE SAME TIME PRESS BUTTON 4
FOUR TIMES
4
RELEASE BOTH BUTTONS
5
AIR4 REMOTE CONTROL LED WILL
START FLASHING BRIEFLY ABOUT
EVERY 2 SEC.
6
PRESS AND HOLD DOWN THE BUTTON TO BE COPIED
FROM THE ORIGINAL REMOTE CONTROL AND WAIT
FOR THE AIR4 LED TO START FLASHING RAPIDLY,
WHICH CONFIRMS ACQUISITION OF THE CODE.
RELEASE THE BUTTON
7
PRESS THE AIR4 REMOTE CONTROL BUTTON TO BE
MEMORIZED. WAIT FOR THE LED TO GO OUT

Copyright by Silca S.p.A. - All Rights Reserved
COPY FIXED CODE REMOTES
with AIR4 Q
AFTER HAVING SELECTED THE ANTENNA TUNING FUNCTION IN EASY SCAN
8
OPEN THE REMOTE CONTROLS
SHELL
9
BRING THE QUARTZ REMOTE CONTROL TO THE
EASY SCAN READING AREA . PRESS AND HOLD A
BUTTON ON THE REMOTE CONTROL. WITH A
CERAMIC SCREWDRIVER SLOWLY TURN THE
ANTENNA’S ADJUSTING SCREW TO OBTAIN THE
MAXIMUM AMPLITUDE OF INTENSITY INDICATED
ON THE EASY SCAN DIPLAY
10
ONCE YOU REACH THE MAXIMUM VALUE, MOVE
THE REMOTE CONTROL SLIGHTLY AWAY FROM THE
EASY SCAN DEVICE AND REPEAT THE PROCESS UNTIL
YOU REACH THE MAXIMUM AMPLITUDE OF
INTENSITY INDICATED ON THE EASY SCAN DISPLAY
11
CLOSE THE REMOTE CONTROLS SHELLS.