MicroBoards Technology Orbit II User manual

Orbit II Stand-Alone CD Copier
820-00150-01 Rev N
This is a reference for basic operation and duplication only. Please read the manual
for more detailed instructions on the advanced features of the Orbit II.
Quick Reference Guide
Basic Duplication
Wide
Input Rod
2 Narrow
Input Rods
Fig. B - Input Rod Positions
Fig. A - Workspace Dimensions
Installation
Instructions
Please save all packing
materials from your Orbit II!
1. Prepare a workspace
for the Orbit II. The
dimensions required for the
Orbit II are shown in Fig. A.
2. Remove thePowerCord,Output
Bin, 3 Input Rods, and Starter Kit
from the box. The Starter Kit
includes the Documentation CD,
Warranty Card, and Quick
Reference Guides. Position the
Orbit II in the prepared space.
3. Make sure theswitch onthe back
of the Orbit II is in the OFF position.
4. Plug the power cord into the back of the Orbit II, then into the
nearest power outlet.
NOTE: It is recommended that you do not use an outlet that
is already powering other equipment.
5. Installthe OutputBin onthe left
side. Extend the bin out to the
left until it snaps into position.
6. InstalltheInput Rodsas shown
in Fig. B.
7. Turn on the Orbit II.
Fig. C - Loading Procedure
Fig. D - Reader Drive Ejected
1. Load discs into the Input Hopper. The
first 5-6 should lay flat, the rest should
lean against the short input hopper rod.
See Fig. C.
2. Press “Yes” when the display reads
“Copy?”
3. Place the Master Disc in the tray when
the reader drive opens. See Fig. D
below.
4. Press the “Yes” key again to start
duplication.
5. When the input hopper is empty, either
add more discs and press “Yes” to
continue, or press “No” to end the
duplication.
6. Once the duplication has been
completed, the reader drive will eject.
Remove the master.
7. Remove the copies from the Accept bin
on the left. Rejected discs, if any, will
be to the right of the Orbit II.
Please refer to the Operator’s Manual for information on the advanced
duplication features of the Orbit II.

Orbit II Stand-Alone CD Copier
820-00150-01 Rev N
The
Y
es key accepts the current display
question, or underlined character in the
Quantity? display.
The No key declines the current display
question, or increments the underlined
character in the
Quantity? display.
Operating Instructions
Menu Tree