4
When replacing lamps and fuses, use the same type and rating only.
Caution: Do not touch the fixture barehanded during its operation, the housing becomes very hot!
CAUTION! BEWARE OF POTENTIAL EYE DAMAGE!
Avoid looking directly into the light source.
(Especially epileptics)!
1.2. Operating the fixture
This fixture is a moving head spot for creating lighting effects. This product has been configured to operate with an
alternating current of 120V 60Hz and was designed for indoor use only.
If the fixturehas been exposed todrastic temperature fluctuations (e.g. after transportation), do not switch it on immediately.
The resulting condensation might damage your fixture. Leave the fixture switched off until it has reached room temperature.
Never operate the fixture without the lamp!
Avoid shaking the fixture or using brute force when installing or operating the fixture.
Never lift the fixture by holding the projector head or arms, as this may damage the pan and tilt motors.
Always hold thefixture by the transport handles.
When choosing the location for installation, please make sure that the fixture is not exposed to extreme heat, moisture or dust.
There should not be any cables lying around. You may endanger yourself and the safety of others!
The minimum distance between light output and the illuminated surface must be greater than 1 meter (3 feet).
Make sure that the area below theinstallation site is blocked off when rigging, de-rigging or servicing the fixture.
Always secure the fixture with an appropriate safety cable. Secure the safety cable by the correct attachments only.
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly fastened.
The lamp mustnever be ignited ifthe objective lensor the housing cover is open asdischarge lamps may explose and
emit a high ultraviolet radiation, which may cause burns.
The maximum ambient temperature of 40°C must never be exceeded.
CAUTION!
The lens has to be replaced when it is so obviously damaged,
that its function is impaired, e. g. due to cracks or deep scratches!
Operate the fixture only after having familiarized yourself with its functions. Do not permit operation by persons not
qualified to operate the fixture. Most damages are the result of unprofessional operation!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Please use the original packaging or a specifically designed flight case if the fixture is to be transported.
Please consider that unauthorized modifications of the fixture areforbidden due to safety reasons!
Never remove the serial barcode from the fixture, as this would make the warranty void.
If this fixture is to be operated in any way different from that described in this manual, the product may suffer damages and
the warranty may become void. Furthermore, any other operation may lead to dangers like short-circuit, burns, electric shock,
lamp explosion, etc.
