13
The FOLLOW ME function enables the
remote control to measure the temper-
ature at its current location. When using
AUTO, COOL, or HEAT functions,
measuring ambient temperature from
the remote control (instead of from the
indoor unit itself) will enable the air
conditioner to optimize the temperature
around you and ensure maximum comfort.
1. Press FOLLOW ME button to activate
function. The remote control will send
temperature signal to the indoor unit
every three minutes.
2. Press FOLLOW ME button again to
turn off this function.
The TURBO function makes the unit work
extra hard to reach your present temperature
in the shortest amount of time possible.
When you press the TURBO button in
COOL mode, the unit will blow cool air
with strongest wind setting to jump-start
the cooling process.
When you press the TURBO button in
HEAT mode, for units with Electric heat
elements, the Electric Heater will activate
and jump-start the heating process.
Airborne bacteria can grow in the moisture
that condenses around heat exchanger in the
unit. With regular use, most of this moisture
is evaporated from the unit. By pressing the
CLEAN button, your unit will clean itself
automatically. After cleaning, the unit will turn
off automatically. Pressing the CLEAN button
mid-cycle will cancel the operation and turn
off the unit.
You can use CLEAN as often as you like.
Note: You can only activate this function
in COOL or DRY mode.
FOLLOW ME function
SWING function
SELF CLEAN function
TURBO function
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Note: The SLEEP function is not available
in FAN or DRY mode.
,
How To Use The Advanced Functions How To Use The Advanced Functions
ON/OFF
ON/OFF
TEMP
TEMP
TIMER
ON
TIMER
ON
TIMER
OFF
TIMER
OFF
MODE
MODE
FAN
FAN
SLEEP
TURBO
TURBO
CLEAN
CLEAN
LED
LED
FOLLOW
FOLLOW
SWING DIRE CT
SILENCE/FP function
MODEL:RG57A6(B)/BGE
F
SILENCE
FP
SILENCE
FP
,
,
Active/Disable SILENCE function. If pushing
more than 2 seconds, the FP function will
be activated, pushing more than 2 seconds
again to disable.
When the Silence function is activated, the
compressor will operate at low frequency
and the indoor unit will bring faint breeze,
which will reduce the noise to the lowest
level and create a quiet and comfortable
room for you. Due to low frequency
operation of compressor, it may result in
insufficient cooling and heating capacity.
The FP function can only be activated
during the heating operation(only when the
setting mode is HEAT).
,
,
14
SWING Button
DIRECT Button
Used to change the louver movement and set
the desired up/down air flow direction.
O
The louver changes 6 in angle for each press.
Used to stop or start horizontal louver auto
swing feature.
SLEEP
SWING
DIRECT
MODEL:RG57A6(B)/BGEF
will beep 0.7 and 0.3 seconds respectively for
entering or exiting 8°C heating mode.
Indoor buzzer
,
The unit will operate
O
at a setting temperature of 8 C
.
Press the buttons of ON/OFF,
SLEEP, FP, MODE, FAN SPEED, UP or
DOWN while operating will cancel the
FP function.
,
