Miller Electric RGCR-1A User manual

OWNER’S MANUAL
1994 MILLER Electric Mfg. Co.
February 1994 FORM: OM-681A
Use above FORM number when ordering extra manuals.
Running Gear/Cylinder Rack (042 700), RGCR-1A (042 745),
And MW150RG (042 804)
ST-149 470-C / ST-800 244
Remove and discard rear
handle of unit before install-
ing
bottle retainer (4).
Description (Qty)
Part
No.
Item
No.
1 602 389 S-Hook (1)
2
148 188 Chain (1)
3 602 384 Snap (1)
4 147 894 Bottle Retainer (1)
5 089 800 Nut, 1/4-20 (2)
6 089 799 Screw , 1/4-20 x 1/2 (2)
7 147 893 Axle (1)
8
090 693 Wheel, 8 in (2)
9 602 250 Washer , 3/4 flat (2)
10 121 614 Retaining Ring (2)
11 148 1 10 Pan (1)
12 602 154 Screw , 1/4-20 x 1/2
self-forming (4)
13 109 318 Caster (2)
14
602 21 1 Washer , 5/16 lock (2)
15 604 537 Nut, 5/16-18 (2)
Be sure to provide Model when ordering
replacement
parts.
5
Remove paint from axle
grooves
(7) before installing re -
taining rings (10).
WARNING
ELECTRIC SHOCK can kill.
•Do not touch live electrical parts.
•Turn Off welding power source and input
disconnect
device.
•Disconnect input power conductors from
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
•Keep cylinders away from welding and other
electrical circuits.
• Never touch cylinder with welding electrode.
•Always secure cylinder to running gear, wall, or
other
stationary support.
FALLING EQUIPMENT can cause injury
and damage.
•Use proper equipment to lift unit.
•Use lifting forks long enough to extend out opposite
side of base.
• Do not put any body part under unit while lifting.
miscwarn1.1 5/93
T ools Needed:
3/8, 7/16, 9/16
123
78910
Crimp Items
1 & 3.
4
11
12
13
14
15
7
Figure 1-1. Installing Running Gear/Cylinder Rack