Miller CST 195 114 User manual

OWNER’S MANUAL OMĆ209 472
May 2002
CST Rack Running Gear (195 114)
WARNING
ELECTRIC SHOCK can kill.
•Do not touch live electrical parts.
•Turn Off welding power source and input disconnect
device.
•Disconnect input power conductors from
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
•Keep cylinders away from welding and other
electricalcircuits.
•Never touch cylinder with welding electrode.
•Always secure cylinder to running gear, wall, or
other stationary support.
FALLING EQUIPMENT can cause injury
and damage.
•Use proper equipment to lift unit.
•Use lifting forks long enough to extend out opposite
side of base.
•Do not put any body part under unit while lifting.
miscwarn1.1* 2/94
803 265
Tools Needed:
9/16 in
Description (Qty)
Part
No.
Item
No.
1 209 396 Running Gear Bkt Assy (4)
2 209 479 Caster (4)
3 601 965 Screw 375-16x1.00 Hex (32)
4 167 788 Nut 375-16 .56 Hex (32)
Be sure to provide Model when ordering
replacement parts.
4
3
1
4
3
2
.Brackets MUST be installed onto rack before installing casters.
Screws and nuts MUST be installed as shown. If CST rack does
not already have bracket holes in the frame, see page 3 for
template to mark hole locations.
13/32 in
Figure 1. Installing Running Gear

OM-209 472 Page 2
1. Hole Location In Rack Using Template For Bracket Assembly
1 Rack Skid
2 Template
If CST rack does not already have
bracket holes in the frame, use the
template on page 3 to mark hole
locations. Use a drill and 13/32 in
drill bit for all holes.
Cut template from page 3 and fold
as indicated by fold lines. Position
templateas shown and mark holes
using a center punch.
.Template must be positioned
with tab labeled “TOP” placed
on top surface of skid.

OM-209 472 Page 3
2. Template For Bracket Assembly Holes In Rack
Cut
Cut
Cut
Cut
Fold
Fold
Fold
Fold
TOP
Cut
Cut
Cut Cut

OM-209 472 Page 4