MIMAKI JV33-130 User manual

Ｄ900675-13
MIMAKI ENGINEERING CO., LTD.
27-Jun-08
1. Purpose
This document descibes how to fix four FFC mounted on JV33-130/160 Slider PCB ASS
Y
to prevent the FFC from breaka
g
e
2. Tools to be used
(1) Phillips screwdriver
3. Parts to be used
(1) Sealing material (sponge)
L=110mm (TM-238-15-15)
(2) Double-stick tape 3 pcs
L=30mm (No.532 width: 8.5mm)
4. Operating time
Approx 30 minutes (Including discharge time (15 min) and operation check)
5. Procedures
(1) Turn the main power OFF and pull the power cable out.
Caution: For electrical discharging, be sure to leave the machine more than 15 minutes
afterturning off to pull the FFC out.
(If pulling the FFC out without electricaldischarging, the printhead and the
main PCB may be broken.)
(2) Remove Wiring cover (M508746)
Caution: Handle the cover with care because the cable for optional ventilation unit
Caution: Do not put the screws on the printer
JV33-130/160 Procedures of fixing FFC
Wiring cover (M508746)
Sealing
material
Double-
stick tape
Slider PCB ASSY
FFC
Ink tubes
Cable clamp
1/3

Ｄ900675-13
(3) Release the connector lock on the Slider PCB ASSY and remove 4 FFC.
Caution1: For electrical discharging, be sure to leave the machine more than
15 minutes afterturning off to pull the FFC out.
Caution2: Treat the lock gently because the lock of CN2 is fragile especially.
(4) Apply the double-stick tape to the following position in the order of Photo A to C and
fix 4 FFC as the Photo D.
Slider PCB
FFC
Double stick
t
30mm
Guide center of FFC
Photo A
45mm
Photo B
65mm
Photo C
18mm
18mm
Guide left of
FFC
Photo D
(Back of FFC)
18mm
Release the
connecotor
Caution
2/3

Ｄ900675-13
(5) Put the sealing material to the cable clamp and put the FFC to the connector.
Caution1: Put the FFC to the connector without bending or folding.
Caution2: Treat the lock gently because the lock of CN2 is fragile especially.
(6) Clamp the FFC with checking a forming.
Caution: Secure a margin of the curved FFC from the connector and the FFC should be
attached vertically from the connector.
(7) Operate [#TEST]-[MOTOR TEST]-[Y SERVO MOTOR] to make the carriage scan with full-width
of the machine continuously (5-10 minutes) and check the FFC is not slipped.
If they are slipped, fix the twisted ink tubes in the cable bear and the position of FFC and check
them again.
(8) Attach Wiring cover (M508746)
Caution: Check the lock of the connector of the cable for optional ventilation unit
FFC should not be exceeded the height of
electrolytic capaciator
FFC should be attached vertically from the
connector.
Sealing material
Cable clamp
Do not bend or fold
10mm
g
a
p
Caution2
3/3