Mitsubishi Electric Smart D90RT User manual

ASSEMBLY GUIDE
The mentioned specications could be sujected to changes
Product images are for illustrative purposes and may dier
Read the following instructions carefully for a correct
installation of the equipment. For more information or
troubleshooting go to:
http://www.mitsubishielectric-printing.com
(EN)
NOTE
CAUTION
!
(EN) CAUTION / (ES) PRECAUCIÓN
(FR) ATTENTION / (DE) VORSICHT
(IT) ATTENZIONE / (PT) CUIDADO
(NL) LET OP
5 easy steps to prepare your PhotoPrintMe service:
1 - Create your Account at www.mecloudprinter.com (“Register new account”)
2 - Register your device into your account “Register New Equipment”
3 - Assemble your SmartD90RT System unit, follow this Guide
5 - Install your POS Kit PhotoPrintMe (POSKITPPM) in your Shop
4 - Edit your products in the Online Catalogue:
4.1 - Go to: mykiosk.io/photoprintme/"SystemID"/admin
And…you are ready to print from PhotoPrintMe!
Do you want to try PhotoID printing service?
1 - Connect to the Smart-D90RT Wifi.
Find Wifi name: #PhotoPrint
Password: 12345678
2 - Go to: http://192.168.110.1:3000
And…you are ready to print PhotoID prints!
www.messec.net > Downloads > SmartID
3 - Check out Online User’s Manual for PhotoID service:
(Check from (4) Section)
QIG - Quick Installation Guide
IMPORTANT: Strongly recommended Internet connection
via Ethernet RJ45 cable.
www.messec.net
without notice.
from the actual product.
Doc v07.18
Check the Verification email!
NOTE: Find "SystemID" in the labelling of your System.
4.2 - Check the manual here:
Connect as User: "supervisor" Password: "12345678"
www.messec.net > Downloads > PhotoprintMe
www.mecloudprinter.com > Help
3 easy steps to prepare your PhotoID service:
[email protected]
Any problem? Contact us: