Mockett WCS4-95 User manual

.....................2X Screws
.................1X Set screw
....................1X Hex Key
.................1X Forstner Bit
.............1X Depth Stopper
.......................1X Drill Bit
.................1X Plastic caliper
....................1X AC Adapter
...........................1X WCS4
TABLE OF CONTENTS:
Loosen set screw on depth stopper with hex key.
2
Measure the thickness of the work surface with
the caliper. (e.g. 25mm or 1")
*When using supplied drill bit.
1
Caliper
Forstner
Bit
Depth
Stopper
Set
Screw
2-1/8"
DIA.
6 ft. CORD
19/32"
GENERAL INFORMATION
1. Mobile device must be equipped with a wireless charging
receiver (Wireless charging accessories not included.)
Check mobile manufacturer for compatibility.
2. USB cable and AC adapter included. AC adapter
specifications 5.0 Volts at 2 Amps output.
3. Wireless output 5W to 10W MAX.
4. Use forstner bit for MDF or particle board wood types ONLY.
Work
Surface
LED
Hex key
*Table thickness: 3/4" Min. to 1-5/8" Max.
.......................1X Decal
2023.11.14 1

Adjust top of depth stopper to match table
thickness obtained from step 1. Make sure
depth stopper aligns with forstner bit as shown.
Tighten set screw.
Top
Scale
(Metric/
Standard)
5 6
4
Use drill bit (included) to make a small hole for
the LED light at the center of the recently drilled
hole. (Note: DO NOT apply excessive force. The
drill bit is fragile.)
Insert wireless charger into opening as shown.
Use (2) screws to tighten unit into the cut out.
Confirm the desired location of the unit on the
underside of the work surface. Slowly drill
straight into the work surface until the blades
engage the wood. Stop when the depth
stopper reaches the surface or leave 4.00mm
[5/32"] MAX. material thickness.
3
Connect and secure the assembled forstner bit
to a power drill. (NOTE: Use forstner bit for
MDF and particle board only. If cutting into
material other than MDF, please use the
appropriate forstner bit for the material.)
TOP VIEW
Drill
Not Included
Underside of work surface
Drill bit
78
Connect USB cable to AC adapter. Plug into
electrical outlet and make sure the cord is not
strained or taut. (Optional: Align the decal on
the worksurface above the unit for pinpoint
accurate wireless charging location.)
AC
Adapter
(OPTIONAL)
Screw
Decal
(OPTIONAL)
2023.11.14 2