Adjust depth stopper to match table thickness
obtained from step 1. Make sure depth stopper
aligns with forstner bit as shown. Tighten set
screw.
Top
Scale
(Metric/
Standard)
5 6
4
Use drill bit (included) to make a small hole for
the LED light at the center of the recently drilled
hole. (Note: DO NOT apply excessive force. The
drill bit is fragile.)
Insert wireless charger into opening as shown.
Use (2) screws to tighten unit into the cut out.
Confirm the desired location of the unit on the
underside of the work surface. Slowly drill
straight into the work surface until the blades
engage the wood. Stop when the depth
stopper reaches the surface or leave 5mm
MAX. material.
3
Connect and secure the assembled fostner bit
to a power drill. (NOTE: If cutting into material
other than MDF, please use the appropriate
fostner bit for the material.)
TOP VIEW
Drill
Not Included
Underside of work surface
Drill bit
7 8
Connect USB cable to AC adapter. Plug into
electrical outlet and make sure the cord is not
strained or taut. (Optional: Align the decal on
the worksurface above the unit for pinpoint
accurate wireless charging location.)
AC
Adapter
(OPTIONAL)
Screw
Decal
(OPTIONAL)
