modway EEI-4634 User manual

Thank you for purchasing the MODWAY Sofa.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the sofa, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Customer Service 609-256-9000︱www.modway.com Page 1 of 4

STEP 1:
1. Please put the Sofa Seat (1) upside down on a carpeted or padded area by two adults.
2. Open the Zipper at the bottom of Sofa Seat (1) and take out the 2 pieces of Front Legs (4), 2 pieces of
Back Legs (5), 1 piece of Middle Leg (9), 2 pieces of Back Cushion Cores (7), 2 pieces of Pillows (8),
Left Arm (2), Right Arm (3) and hardware bag.
STEP 2:
1. Tighten 2 pieces of Front Legs (4) to the front bottom of the Sofa Seat (1) clockwise as shown by hand.
2. Attach 2 pieces of Back Legs (5) to the Sofa Seat (1) by using 2 pieces of Bolts (A) and 2 pieces of
Flat Washer (B) as shown with Figure . Use Allen Wrench (C) to tighten all Bolts (A).
3. Tighten 1 piece of Middle Leg (9) to the middle bottom of the Sofa Seat (1) clockwise as shown by hand.
Customer Service 609-256-9000︱www.modway.com Page 2 of 4

STEP 3:
1. Please carefully turn over Sofa Seat (1).
2. Insert Left Arm (2) and Right Arm (3) to Sofa Seat (1) by using the pre-installed Clips on Sofa Seat (1),
Left Arm (2) and Right Arm (3) to lock each other as shown.
STEP 4:
Insert Sofa Back (6) to Left Arm (2) and Right Arm (3) by using the pre-installed Clips on Left Arm (2),
Right Arm (3) and Sofa Back (6) to lock each other as shown.
Customer Service 609-256-9000︱www.modway.com Page 3 of 4

STEP 5:
1. Open the compressed bag with scissors and take out 2 pieces of Back Cushion Cores (7) as shown
with Figure 1.
2. Please put Back Cushions Cover (10) on a carpeted or padded area and fully open the zipper as shown.
Insert 1 piece of Back Cushions Core (7) into Back Cushion Cover (10) until the Foam is fully embedded into
the Cover and Zip up the Cover as shown.
3. Repeat the same steps for the remaining piece of Back Cushions Core (7) and Back Cushion Cover(10).
STEP 6:
Carefully put 2 pieces of Back Cushion (7) and 2 pieces of Pillows (8) to the assembled Sofa Seat (1),
Left Arm (2), Right Arm (3) and Sofa Back (6) as shown.
Assembly is complete. Your sofa is ready to enjoy now !
Customer Service 609-256-9000︱www.modway.com Page 4 of 4

SOFA USER GUIDELINE
This product makes a long journey to reach you and the cushion is
compressed, please reshape the cushion to restore to its original
beauty before using, steps as follows:
1.Carefully remove the plastic packing
and put the cushion on a flat surface in
a well ventilated room and allow 48
hours for expansion.
2.Press the back cushions with both
hands from side edge.
3.Press the back cushions with both
hands from front side.
4.Restoring action is complete,you
can put it to the back cushion cover
and then put it in the assembled
sofa now.