modway EEI–2323 Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI–2323 BENCH
Hardware:
Component:
A Bolt M6x40mm x 12
C
1
Bench Body x1 3 Middle Rail x1
Thank you for purchasing the MODWAY BENCH!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
1
F
2
Spring Washer M6 x 12
Allen Wrench x 1
D Flat Washer M6 x 14
2
E Plastic Washer x 2
2
2
2 Bench Leg x4
3
B Bolt M6x60mm x 2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI–2323 BENCH
STEP 1:
STEP 2:
Hardware & Tool required
Put Bench Body (2) on a carpeted or padded area.
Position 1 piece of Bench Leg (2) to the apron inside without wooden block at first.
Attach by using 3 pieces of Short Bolt (A), 3 pieces of Spring Washer (C) and 3 pieces of Flat Washer (D) as shown.
Then position another pieces of Bench Leg (2) to the apron inside with wooden block.
Attach by using 3 pieces of Short Bolt (A), 3 pieces of Spring Washer (C) and 3 pieces of Flat Washer (D) as shown.
Repeat the same steps for the remaining Bench legs (2) to the other side of Bench Body (1).
Do not fully tighten the Short Bolts (A) at this step.
Ax12 Dx12 Dx12
F
E
B
A
Hardware & Tool required
Bx2 Dx2 Ex2 Fx1
Position Middle Rail (3) to the assembled Bench Legs (2) as shown.
Attach by using 2 pieces of Long Bolt (B), 2 pieces of Spring Washer (D) and 2 pieces of Plastic Washer (E).
Use Allen Wrench (F) to tighten all the Bolts (A&B) clockwise until secure at this step.
Assemble this leg at first.
C
1
A
C
D
2
2
2
2
D
E
D
B
D
F

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI–2323 BENCH
STEP 3:
Assembly is completed. Your bench is ready to be enjoyed now!
Carefully turn over the assembled bench.