modway EEI-3025 User manual

EEI-3025 SIDE TABLE
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 1 of 3
Thank you for purchasing the MODWAY SIDE TABLE.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 20 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
A. Bolt 1/4”x35mm x 6
B. Flat Washer x 6
C. Allen Wrench x1
Component:
1 Top Panel x1 2 Legs x 2 3 Glass x 1
1
2
2
3

EEI-3025 SIDE TABLE
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 2 of 3
STEP 1:
Please put Top Panel (1) on a carpeted or padded surface.
Attach 1 piece of Leg (2) to the bottom of Top Panel (1) by using 3 pieces of Bolts (A) with 3 pieces of Flat
Washers (B) as shown. Tighten Bolts (A) by using Allen Wrench (C) as shown.
Hardware & Tools required
STEP 2:
Attach the other piece of Leg (2) to the bottom of Top Panel (1) by using 3 pieces of Bolts (A) with 3 pieces of
Flat Washers (B) as shown. Tighten Bolts (A) by using Allen Wrench (C) as shown.
Hardware & Tools required
1
2
A
C
B
A
x 3
x 3
B
x 1
C
2
1
A
C
B
A
x 3
x 3
B
x 1
C

EEI-3025 SIDE TABLE
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 3 of 3
STEP 3:
Carefully turn over the assembled Top Panel (1) and legs (2) from step 2 as shown.
STEP 4:
Put Glass (3) on Top panel (1) as shown.
Assembly is complete. Your Table is ready to be used now!
1
3
1
2
2