Montigo DRSQT34 User manual

xT0072 - 031320
Installation
DRLT36, DRLT36-2, DRLT48, DRLT48-2, DLT63,
DLT63-2, DRSQT34, DRSQT34-2, DRSQT38,
DRSQT38-2, DRSQT42, DRSQT42-2,
DRSQT46, DRSQT46-2
1” AdjustAble trim kit
ThiS SecTion onLy foR DeLRay LineaR
ScReenS manufacTuReD befoRe may 2020
• TheinstallationofthisKITmustbedonebyaqualiedand
certiedgasapplianceinstaller.
• Checklocalcodesandreadallinstructionspriortoinstallation.
Installer: Leave this manual with the appliance.
Consumer: Retain this manual for future reference.
Notice
Assembly
1
2
3
5
6
4
The facing material should be fully finished before
installation of the trim kit.
The Trim slides on the inside of the flush frame of the opening. Push in until the trim is flush
with the facing material.
Ensure the all 4 corners of the trim kit are squared off. Before installation orient the trim so
the notched section is on the bottom.
The trim can slide in and out to the full depth of the facing material providing it falls within
the depth limits of the trim kit. A construction adhesive can be used to better secure the trim.
Before construction and installation of the trim kit can
begin, the bottom ⅛" off the DelRay screen tabs must
be trimmed.
Pleaserefertoyourratingplateserialnumberforthedateof
manufacture.Ifunsure,measurethelengthofthetabs,ifitis
below¼”,itdoesnotneedmodification.
Slide the side pieces into the top and bottom tracks.
Some materials used in the manufacturing process of this product can
expose you to Benzene which is known in the State of California to
cause cancer and birth defects or other reproductive harm. For more
information go to www.P65warnings.ca.gov
WarNiNg
Cornerssquaredoff
Notch
onthe
bottom

xT0072 - 031320
Installation
DLT36, DLT36-2, DLT48, DLT48-2, DLT72, DLT72-2
1” AdjustAble trim kit
• TheinstallationofthisKITmustbedonebyaqualiedand
certiedgasapplianceinstaller.
• Checklocalcodesandreadallinstructionspriortoinstallation.
Installer: Leave this manual with the appliance.
Consumer: Retain this manual for future reference.
Notice
Assembly
1
24
5
3
The facing material should be fully finished before
installation of the trim kit.
The Trim slides on the inside of the flush frame of the opening. Push in until the trim is flush
with the facing material.
Ensure the all 4 corners of the trim kit are squared off.
The trim can slide in and out to the full depth of the facing material providing it falls within
the depth limits of the trim kit.
Slide the side pieces into the top and bottom tracks.
Some materials used in the manufacturing process of this product can
expose you to Benzene which is known in the State of California to
cause cancer and birth defects or other reproductive harm. For more
information go to www.P65warnings.ca.gov
WarNiNg
The trim kit will mount with
magnets to the inside edge
of this lip
Cornerssquaredoff
ThiS SecTion onLy foR
DiSTincTion TRimS DLT72, DLT72-2
6Secure the top of the trim to the finishing material with the included screw to
prevent bowing of the top trim piece when heated.