Motoalliance DENALI MA11762 User manual

866.527.7637 1 [e-mail]
23001 Industrial Blvd, Rogers, MN 55374 / 1-866-527-7637
www.motoalliance.com
DENALI Plow Mount
MA11762
Prowler Plow Mount
Thank you for purchasing our Denali plow mount. You now own a premium custom plow
mount which allows you to use your plow with your UTV / SxS. Please note the
following instructions and heed all warnings.
•Please use common sense when operating your UTV / SxS
•Be observant of moving parts causing entanglement, use extreme caution!
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

MA11762
23001 Industrial Blvd
Arctic Cat Prowler Plow Mount Rogers, MN 55374
866.527.7637
866.527.7637 2 [e-mail]
Please verify that all hardware and parts are included in your package.
Kit Contents:
Item
Description
QTY
1
MA11762-W1 Main Mount Plate
1
2
MA11762-2 Spacer Plate
2
3
3/8’’-16 x 1.25’’ Serrated Flange Bolt
4
4
3/8’’-16 Serrated Flange Nut
4
Figure 1

MA11762
23001 Industrial Blvd
Arctic Cat Prowler Plow Mount Rogers, MN 55374
866.527.7637
866.527.7637 3 [e-mail]
1. Remove the two screws from the lower plastic facia of the Prowler as shown in Figure 2
Figure 2
2. Remove the two Torx screws from the side of the plastic facia as shown in Figure 3.
Figure 3

MA11762
23001 Industrial Blvd
Arctic Cat Prowler Plow Mount Rogers, MN 55374
866.527.7637
866.527.7637 4 [e-mail]
3. Remove the tie down rails by removing the nuts on the back side of the vehicle frame. See Figure 4.
Figure 4
4. Set aside the plastic facia. Position one of the spacer plates over the holes used by the tie down rails and
then place the main plow mount over the spacer plate. Align the two holes and place two of the 3/8’’ included
hardware through the holes. Loosely secure the hardware using the included 3/8’’ nuts but do not tighten.
5. Place the second spacer plate behind the main mount plate on the opposite side and insert the remaining
3/8’’ bolts through the holes. Secure using the included 3/8’’ serrated flange nuts. Tighten all hardware.
6. Install the Denali plow to the plow mount per the plow instructions. See Figure 5
Figure 5
7. After the first plowing, verify all hardware is secure.