Motoalliance VIPER PLOW User manual

www.motoalliance.com
1-866-527-7637
23001 Industrial Blvd, Rogers, MN 55374 / 1-866-527-7637 / www.motoalliance.com
VIPER PLOW SYSTEM
Kawasaki Prairie 360 and Brute Force 650
MA11131
Thank you for purchasing the premium VIPER PLOW system. You now have a top-of-the-
line plow system to using for shoving aside snow and dirt with the use of your ATV. Please
note the following instructions and heed all warnings.
WARNING!!!
SEVERE INJURY OR DEATH MAY RESULT IF YOU IGNORE ANY OF
THE FOLLOWING.
−Read the Plow Operator’s Manual, the Winch Operator’s Manual, and all warning labels
before operating.
−Operate ATV at a walking speed with the blade installed. Do Not exceed 5mph (8 km/h)
even with the blade up.
-Plow Cautiously, impact with a hidden or stationary object may cause the ATV to stop
suddenly or go out of control.
--Do Not operate the ATV on slopes greater than 10° with the plow installed.
−Do Not stand or ride on the plow.
Stay clear of moving parts and joints. Keep others away when operating or adjusting plow.
−Inspect the plow mechanism, fasteners, cable, and adjustments before operating. Replace
all worn or damaged parts before operating.
−Lower the plow to the down position before leaving the ATV
unattended.

www.motoalliance.com
1-866-527-7637
PARTS LIST
(8) 5/16” Nylock Nut
(4) 5/16” x 1.5” x 2.25” u-bolt (42021)
Plow Mount Assembly:
To install the plow mount to the underside of the
vehicle install the front two U-bolts PN 42021, and
loosely tighten the 5/16” nuts. Pull the plow mount back
in the furthest position and then fully tighten, as shown
in Figure 2.
For the Kawasaki Prairie 360 use the second set of U-
bolts PN 61262 and securely tighten around the frame in
hole location (B).
For Kawasaki Brute Force 650 and Suzuki Twin Peaks
700 drill a 3/8” hole through the aluminum skid plate,
using the plow mount as a template, as shown in Figure
3. Repeat the same process on the other side.
After both holes are drilled attach the mounting plate
with the second set of U-bolts PN 42021 and securely
tighten around the frame in hole location (A).
Tighten all fasteners securely. Torque 5/16” Bolts: 20ft.
lb.
Plow Installation:
Slide the plow into position with the tubes under the
ATV.
Lift the end of the tube assembly into position so the
holes in the Tube Wings line up with the 3/8” holes in
the frame brackets (Fig. 2).
If using a winch, mount the plow in the rear holes using
the 3/8” pins that came with the plow kit. If using the
electric actuator or manual lift, mount the plow in the
forward holes.
A Phillips head screwdriver may be used to align the
holes.
Hole Locations