STOW PORTO MIXER — PARTS & OPERATION MANUAL — REV. #0 (08/08/03) — PAGE 9
■
High Temperatures – Always stop engine and allow the
engine to cool before adding fuel, oil or performing service
andmaintenancefunctions.Contactwith
hot
componentscan
causeserious burns.
■
NEVER disconnect any
"emergency or safety devices"
.
These devices are intended for operator safety.Disconnection
of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all
warranties.
■
If mixer is equipped with an electric motor, operate
only
at
120VAC, 60Hz.
■
Make sure the
OFF/ON
power switch is always in the
OFF
position before inserting the mixer's power plug into an AC
receptacle(electric model only).
Maintenance Safety
■
NEVERlubricatecomponentsorattemptserviceonarunning
machine.
■
ALWAYS allow the machinea properamountof timeto cool
beforeservicing.
■
Keepthemachinery in proper running condition.
■
Fixdamagetothemachineimmediatelyandalways replace
brokenparts, or missingdecals.
■
Disposeofhazardouswasteproperly.Examplesofpotentially
hazardouswaste are used motoroil,fuel and fuel filters.
■
DO NOT use food or plastic containers to dispose of
hazardouswaste.
■
DO NOT pour waste, oil or fuel directly onto the ground,
downadrainor into any water source.
RULES FOR SAFE OPERATION
■
NEVER Run engine without air cleaner. Severe engine
damage may occur.
■
ALWAYS read, understand, and follow procedures in
Operator’s Manual before attempting to operate equipment.
■
ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using roller.
■
ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■
NEVER leave the mixer unattended, turn off engine or electric
motor when unattended.
■
CAUTION mustalwaysbeobservedwhileservicingthis mixer.
Rotating parts can cause injury if contacted.
■
Unauthorized equipment modifications will void all
warranties.
■
Ensure that any trailing cable is protected against damage
and not liable to be tripped over or trapped underneath the
mixer.
■
Ensureanyextentioncablesmustbenolongerthan30meters
(100feet) in length and that thewiresection is 2.5 mm 2.
■
DONOT allowextensioncordtocomeintocontactwithwater
orfluids.
■
DO NOT spraywaterontoelectric motor.
■
DO NOT expose power tools to
rain
or
wet
conditions.
■
Thismixerisintended fortheproduction ofconcrete,mortar
andplaster. Mixermustbeusedonlyforitsintendedpurpose.
■
This mixer is not suitable for the mixing of
flammable
or
explosive
substances.
■
NEVER operatethe mixer inan
explosive
atmosphere.
■
Beforestartingthemixer,checkthatall
guards
areinposition
andcorrectly fitted.
■
DONOTtipmixerontodrummouthwhenthemotorisrunning.
■
Keep area around the mixer
clear of obstructions
which
could cause persons to fall onto
moving parts
.
■
ALWAYS ensure mixer is on level ground before mixing.
■
Become familiar with the controls of the machine before
operating.
■
ALWAYS replace anyworn or damaged warning decals.
■
Ensure the drum is
rotating
while filling and emptying the
drum.
■
ALWAYS disconnect AC power plug from power source
beforemoving mixer (electric modelonly).
Go to Discount-Equipment.com to order your parts
