MULTISPAN DIN-63C User manual

OPERATING MANUAL
MULTIRANGE TIMER
DIN-63C
Technical Specification
LED
Connection Diagram
3 Digit Seven Segment LED Display
Up & Down Selectable
Power Supply
Operating
Temperature
Relative
Humidity
100 to 270V AC, 50/60Hz
Up to 95% RH Non Condensing
Model
Display
Dirction
Size (mm)
Range
Output
76 (H) x 27 (W) x 116 (D) mm
0 to 999 Second/Minute/Hours and
Decimal Point Selectable
1 Relay with 2C/O (5 Amps/230V AC)o/p
DIN-63C
0° To 55°
C C
Display
All Led are in Red color.
RLY : Shows the relay status.
M : Shows that the set time is in minutes.
H : Shows that the set time is in hours.
S : Shows that the set time is in seconds.
DIN-63C
www.multispanindia.comPage-2

999
UP KEY
ON
After 4 seconds instrument will save the current
count as ON TIME and will auto exit.
After 4 seconds instrument will save the current
count as ON TIME and will auto exit.
Press key OR key
to change the ON TIME
Press key display will show ON
Press key display will show OFF
UP KEY
999
Press key OR key
to change the OFF TIME
OFF
MENU
DIN-63C
www.multispanindia.comPage-2

DIN-63C
www.multispanindia.comPage-3
AA
BC
MODEL A
76mm 27mm 116mm
BC
DIMENSIONS
Allsafetyrelatedcodifications,symbolsandinstructionsthatappearinthisoperatingmanual
orontheequipmentmustbestrictlyfollowedtoensurethesafetyoftheoperatingpersonnelas
wellastheinstrument.
Ifalltheequipmentisnothandledinamannerspecifiedbythemanufacturer,itmightimpairthe
protectionprovidedbytheequipment.
=>Readcompleteinstructionspriortoinstallationandoperationoftheunit.
WARNING:Riskofelectricshock.
3)Cableusedforconnectiontopowersource,musthaveacrosssectionof1mmorgreater.Thesewires
shouldhaveinsulationscapacitymadeofatleast1.5kV.
2)Toreduceelectromagneticinterference,usewirewithadequateratingandtwistsofthesameof
equalsizeshallbemadewithshortestconnection.
1)TopreventtheriskofelectricshockpowersupplytotheequipmentmustbekeptOFFwhiledoingthe
wiringarrangement.Donottouchtheterminalswhilepowerisbeingsupplied.
4)Abetteranti-noiseeffectcanbeexpectedbyusingstandardpowersupplycablefor
theinstrument.
1)Donotallowpiecesofmetal,wireclippings,orfinemetallicfillingsfrominstallationtoenterthe
productorelseitmayleadtoasafetyhazardthatmayinturnendangerlifeorcauseelectricalshockto
theoperator.
2)Circuitbreakerormainsswitchmustbeinstalledbetweenpowersourceandsupplyterminalto
facilitatepowerʻONʼorʻOFFʼfunction.Howeverthismainsswitchorcircuitbreakermustbe
installedatconvenientplacenormallyaccessibletotheoperator.
3)Useandstoretheinstrumentwithinthespecifiedambienttemperatureandhumidityrangesas
mentionedinthismanual.
WarningGuidelines
InstallationGuidelines
MechanicalInstallation
Maintenance
SafetyPrecautions
1)ToinstalltheinstrumentonaDINrail,raisetheclampatthebackoftheinstrumentandplaceiton
therail.Nowreleasetheclamp,sotheinstrumentfitsontheDINrail.
2)Ensureproperfittingoftheinstrumentbypullingitoutwards.
3)ToremovetheinstrumentraisetheclamptoreleaseitfromtheDINrail.
4)Theequipmentinitsinstalledstatemustnotcomeincloseproximitytoanyheatingsource,
causticvapors,oilssteam,orotherunwantedprocessbyproducts.
5)Donotconnectanythingtounusedterminals.

1)Theequipmentshouldbecleanedregularlytoavoidblockageofventilatingparts.
2)Cleantheequipmentwithacleansoftcloth.Donotuseisopropylalcoholoranyothercleaningagent.
3)Fusibleresistormustnotbereplacedbyoperator.
2

DIN-63C
www.multispanindia.comPage-4
Note
Productimprovementandupgradeisaconstantprocedure.SoformoreupdatedoperatinginformationandSupport,
PleasecontactourHelpline:[phone]/76/82orEmailat[email protected]Ver:2006